Decision Notice - 010.2007.00000604.001 [As Published] · 142007.604

NOOSA COUNCIL IDAS Development Application Decision Notice                                                     4 of 8


17.    Prior to commencement of earthworks and removal of trees, all existing trees nominated for retention on
       the approved Council plans must be cordoned off with protective barricade fencing to prevent impact from
       all future construction works.

18.    All target or hazard pruning required on trees to be retained must be carried out by a qualified
       experienced arborist.

19.    The applicant must ensure that all landscaping treatment does not unduly restrict/prevent access to
       service meters within the site.

20.    This Development Permit lapses if the development has not happened by 16 January 2010 unless
       application to extend the currency is approved by Council.
Frontage Works, Access, Car Parking, Stormwater Disposal, Sediment & Erosion Controls and Filling of the Site.
21.    The development shall be carried out in accordance with drawings Nos.

              Plan A        undated                              by Murray & Associates

              Plan B        dated 23 March 2007                  by Murray & Associates

              or as modified herein.

22.    Council’s stop valve lid in existing footpath to be regraded, shall be raised to be flush with the new
       concrete footpath level. Please contact Council’s Water & Sewerage Section prior to works commencing.

23.    All heavy plant shall be transported to the site via the National Park track, provided that Queensland
       Parks & Wildlife Service agrees to the use of the track. Park Road the access road to the site has a 9
       tonne limit, all vehicles using Park Road must abide by this load limit.

24.    No queuing of trucks is permitted in Viewland Drive, Bayview Road or other residential streets in the
       vicinity of the site.

25.    Suitable sediment control devices ("in pit” pollution control devices) shall be temporarily installed into the
       first existing external downstream stormwater structure.
       These devices are to be checked and cleaned on a regular basis and specifically after each rain event.
       These devices are to remain in place during the civil works and construction phases of the development.
       The location and type of device to be installed shall be established at the “pre start” meeting with
       Council’s Construction Technical Officer and shall be installed prior to the commencement of any works.
26.    A site control and/or compliance bond of $2000 is to be submitted to Council prior to the pre-start
       meeting. The pre-start meeting will only be held once Council's Construction Technical Officer has
       confirmation that the bond monies have been received by Council.

       The bond will be refunded less any costs incurred by Council in ensuring compliance with these
       conditions or any additional inspections incurred for substandard work or work undertaken not in
       accordance with this permit.

27.    Council’s Construction Technical Officer - Mick Conroy (ph 0410 512 505), shall be given seven (7) days’
       notice of intention to commence works to arrange a “pre start” meeting regarding the civil works.

28.    The principal contractor must have all the appropriate insurance and public liability documentation to carry
       out the works. The principal contractor is also responsible to ensure that any sub contractors also have
       the appropriate insurance and public liability documentation.

29.    Prior to the “pre start” meeting, the principal contractor must be provided with a copy of Council’s
       signed approved drawings and conditions by the applicant.

30.    Prior to works commencing, Council is to be advised of the Engineer (RPEQ) supervising the project.
       (This person will be the contact for the project).

31.    Council standards shall apply to these works unless otherwise modified herein.




MSOffice c:\docume~1\shesse\locals~1\temp\bcl technologies\easypdf 5\@bcl@1c0d89ce\@[email protected]