Decision Notice - 010.2008.00000611.001 [As Published] · 142008.611

                                                    -2-



       and as may be amended by these conditions.
2.     Structures should be designed and constructed such that they are free standing within the
       waterway and are not connected to or behind the revetment wall.
3.     The boat lifting device is to be located in conjunction with the approved jetty and shall not
       extend beyond the end of the approved jetty and with an overall width no greater than 3.0m.
4.     The boat lifting device is to be fixed to the approved jetty as such it forms part of the structure
       and generally perpendicular to the revetment wall.
5.     There shall be no electrical reticulation system carrying electricity in excess of 24 volts beyond
       the revetment wall.
6.     Lighting associated with the use shall be designed, installed, operated, and maintained in
       accordance with Section 3 of AS4282 Control of the Obtrusive Effects of Outdoor Lighting.
7.     The boat lifting device is to be used for private purposes only with no commercial operations to
       be undertaken.
8.     Boat repair activities will not be permitted on site.
9.     Wastewater and sullage shall only be disposed of at approved pumpout facilities.
10.    The mooring facility shall not be utilised for live-aboard purposes.
11.    Any construction and post construction activity is not to impact on the condition of the
       waterway, and is to be conducted so as not to breach the Environmental Protection Act EPA
       (1994) and the Environmental Protection (Water) Policy 1997.
12.    The approval or conditions do not constitute a ruling on structural safety and the applicant
       must make their own arrangement to ensure adequacy of design and work. Also any approval
       granted does not warrant that such plans and specifications have been checked in detail, nor
       does it absolve the owner of the land from complying with all the conditions of this approval
       and/or relevant Council By-Laws and Policies and/or relevant statues and/or statutory
       regulations in the execution and/or performance of said works. The Council does not accept
       any responsibility for the accuracy of such plans
13.    Certification by a Registered Professional Engineer of Queensland that states that the boat
       lifting device has been constructed in accordance with best practice methods and are
       structurally sound shall be submitted to Council prior to the return of any bond monies held by
       Council. A final inspection and approval of the structures by Council’s Inspector is also
       required prior to the return of any bond monies held by Council. Please contact Council’s
       Land Development Section to arrange the inspection.
14.    The boat lifting device shall be licensed with the Council upon completion of the structural
       work and shall be licensed annually thereafter.

5      REFERRAL AGENCY CONDITIONS
The referral agencies applicable to this application are:

 Referral Trigger             Referral Status      Referral Agency        Referral Address

 Nil

6      APPROVED PLANS/DOCUMENTS
The approved plans and / or documents for this development approval are listed in the following
table:
 Plan / Document No.        Rev.    Plan / Document Name                        Date

                                                                                                Page 2 of 6