Acid Sulfate Management Plan · MCU16/0103

                                                                                                                                     BE018333 R0




     FOOTNOTES



     IS     Insufficient sample for analysis.                           LOR      Limit of Reporting
    LNR     Sample listed, but not received.                             ↑↓      Raised or Lowered Limit of Reporting
      *     NATA accreditation does not cover the                       QFH      QC result is above the upper tolerance
            performance of this service.                                QFL      QC result is below the lower tolerance
      **    Indicative data, theoretical holding time exceeded.           -      The sample was not analysed for this analyte
                                                                        NVL      Not Validated



    Samples analysed as received.
    Solid samples expressed on a dry weight basis.

    Where "Total" analyte groups are reported (for example, Total PAHs, Total OC Pesticides) the total will be calculated as the sum of the individual
    analytes, with those analytes that are reported as <LOR being assumed to be zero. The summed (Total) limit of reporting is calcuated by summing
    the individual analyte LORs and dividing by two. For example, where 16 individual analytes are being summed and each has an LOR of 0.1 mg/kg,
    the "Totals" LOR will be 1.6 / 2 (0.8 mg/kg). Where only 2 analytes are being summed, the " Total" LOR will be the sum of those two LORs.

    Some totals may not appear to add up because the total is rounded after adding up the raw values.

    If reported, measurement uncertainty follow the ± sign after the analytical result and is expressed as the expanded uncertainty calculated using a
    coverage factor of 2, providing a level of confidence of approximately 95%, unless stated otherwise in the comments section of this report.

    Results reported for samples tested under test methods with codes starting with ARS -SOP, radionuclide or gross radioactivity concentrations are
    expressed in becquerel (Bq) per unit of mass or volume or per wipe as stated on the report. Becquerel is the SI unit for activity and equals one
    nuclear transformation per second.
    Note that in terms of units of radioactivity:
         a.     1 Bq is equivalent to 27 pCi
         b.     37 MBq is equivalent to 1 mCi

    For results reported for samples tested under test methods with codes starting with ARS -SOP, less than (<) values indicate the detection limit for
    each radionuclide or parameter for the measurement system used. The respective detection limits have been calculated in accordance with ISO
    11929.

    The QC criteria are subject to internal review according to the SGS QAQC plan and may be provided on request or alternatively can be found here :
    http://www.sgs.com.au/~/media/Local/Australia/Documents/ Technical%20Documents/MP-AU-ENV-QU-022%20QA%20QC%20Plan.pdf

    This document is issued, on the Client's behalf, by the Company under its General Conditions of Service available on request and accessible at
    http://www.sgs.com/en/terms-and-conditions. The Client's attention is drawn to the limitation of liability, indemnification and jurisdiction issues
    defined therein.

    Any other holder of this document is advised that information contained hereon reflects the Company 's findings at the time of its intervention only
    and within the limits of Client's instructions, if any. The Company's sole responsibility is to its Client and this document does not exonerate parties to
    a transaction from exercising all their rights and obligations under the transaction documents.

    This report must not be reproduced, except in full.



21-October-2016                                                                                                                                          Page 5 of 5