Acid Sulfate Management Plan · MCU16/0103

                                                                         FOOTNOTES                                                        BE018333 R0



   Samples analysed as received.

   Solid samples expressed on a dry weight basis.

   QC criteria are subject to internal review according to the SGS QA /QC plan and may be provided on request or alternatively can be found here :
   http://www.sgs.com.au/~/media/Local/Australia/Documents/ Technical Documents/MP-AU-ENV-QU-022 QA QC Plan.pdf




                     *        NATA accreditation does not cover tthe performance of this service .
                     -        Sample not analysed for this analyte.

                    IS        Insufficient sample for analysis.
                   LNR        Sample listed, but not received.
                   LOR        Limit of reporting.
                   QFH        QC result is above the upper tolerance.
                   QFL        QC result is below the lower tolerance.



                    ①         At least 2 of 3 surrogates are within acceptance criteria.
                    ②         RPD failed acceptance criteria due to sample heterogeneity.
                    ③         Results less than 5 times LOR preclude acceptance criteria for RPD.
                    ④         Recovery failed acceptance criteria due to matrix interference.
                    ⑤         Recovery failed acceptance criteria due to the presence of significant concentration of analyte (i.e. the
                              concentration of analyte exceeds the spike level).
                    ⑥         LOR was raised due to sample matrix interference.
                    ⑦         LOR was raised due to dilution of significantly high concentration of analyte in sample.
                    ⑧         Reanalysis of sample in duplicate confirmed sample heterogeneity and inconsistency of results.
                    ⑨         Low surrogate recovery due to the sample emulsifying during extraction.
                    ⑩         Sample(s) #<SAMPLE NUMBERS> was not able to be performed due to interference from high < ANALYTE
                              NAME>.
                    ⑪         Recovery failed acceptance criteria due to matrix heterogeneity.
                     †        Refer to Analytical Report comments for further information.




   This document is issued, on the Client's behalf, by the Company under its General Conditions of Service, available on request and accessible at
   http://www.sgs.com/en/terms-and-conditions. The Client's attention is drawn to the limitation of liability, indemnification and jurisdiction issues defined
   therein.

   Any other holder of this document is advised that information contained herein reflects the Company 's findings at the time of its intervention only and
   within the limits of Client's instructions, if any. The Company's sole responsibility is to its Client and this document does not exonerate parties to a
   transaction from exercising all their rights and obligations under the transaction documents.

   This test report shall not be reproduced, except in full.



21/10/2016                                                                                                                                               Page 9 of 9