Decision Notice - 010.2009.00000943.001 [As Published] · 142009.943

                                                                                         2009/943



      09/99-3                             Working DRG - John Norden and              July 2009
                                          Associates

2.    Structures shall be designed and constructed such that they are free standing within the
      waterway and are not connected to or behind the revetment wall.
3.    The jetty shall have a level-walking surface of R.L 1.000 A.H.D or be level with the top of the
      revetment wall.
4.    A rigid handrail shall be fitted on one side of the walkway.
5.    No posts or vertical supports of the proposed jetty are to extend vertically from the structure
      unless they provide support for the handrail.
6.    The boat lifting device is to be located in conjunction with the approved jetty and shall not
      extend beyond the end of the approved jetty and with an overall width no greater than 4.0m.
7.    There shall be no electrical reticulation system carrying electricity in excess of 24 volts beyond
      the revetment wall.
8.    Lighting associated with the use shall be designed, installed, operated, and maintained in
      accordance with Section 3 of AS4282 Control of the Obtrusive Effects of Outdoor Lighting.
9.    Rock scour protection, wrapped in geotextile, extends 750mm from the face of the revetment
      wall in this locality. Piles are to be located clear of this rock protection.
10.   The jetty is to be used for private purposes only with no commercial operations to be
      undertaken.
11.   Boat repair activities will not be permitted on site.
12.   Wastewater and sullage shall only be disposed of at approved pumpout facilities.
13.   The mooring facility shall not be utilised for live-aboard purposes.
14.   Any construction and post construction activity is not to impact on the condition of the
      waterway, and is to be conducted so as not to breach the Environmental Protection Act EPA
      (1994) and the Environmental Protection (Water) Policy 1997.
15.   The approval or conditions do not constitute a ruling on structural safety and the applicant
      must make their own arrangement to ensure adequacy of design and work. Also any approval
      granted does not warrant that such plans and specifications have been checked in detail, nor
      does it absolve the owner of the land from complying with all the conditions of this approval
      and/or relevant Council By-Laws and Policies and/or relevant statues and/or statutory
      regulations in the execution and/or performance of said works. The Council does not accept
      any responsibility for the accuracy of such plans
16.   Certification by a Registered Professional Engineer of Queensland that states that the jetty
      and boat lift are constructed in accordance with best practice methods and are structurally
      sound shall be submitted to Council prior to the return of any bond monies held by Council. A
      final inspection and approval of the structures by Council’s Inspector is also required prior to
      the return of any bond monies held by Council. Please contact Council’s Land Development
      Section to arrange the inspection.
17.   The Development Permit for Operational Works (Jetty and Above Water Boat Storage) lapses
      if the works have not been completed by 17 August 2011, unless an application to extend the
      relevant period is approved by Council.
18.   The jetty shall be licensed with the Council upon completion of the structural work and shall be
      licensed annually thereafter.




                                                                                       Page 2 of 6