Skip to the record
Noosa's #1 Council Tracker.

Original source · versioned page text

Engineering_Integrated Water Management Plan

of 34

Page text shows just the words. Original shows the document exactly as it was published.

Page text read automatically using OCR, there may be inaccuracies

Plans and drawings

This document appears to be plans or drawings. Its page text below holds only the words printed on the drawings, without the drawings themselves, so it may be jumbled or hard to follow. To see the plans as drawn, choose Original above or download the file (both need you to log in).

Log in to see the plans as drawn
Table 9: Bioretention Basin Design Parameters

                    Parameter                     B             C             D
        Extended Detention Depth (m)              0.2          0.2            0.1
                                      2
           Storage Surface Area (m )              60           35             20
                                  2
            Filter Media Area (m )                50           30             15
      Unlined Filter Media Perimeter (m)         0.01         0.01           0.01
   Saturated Hydraulic Conductivity (mm/hr)      200          200            200
               Filter Depth (m)                   0.5          0.5            0.5
      TN Content of Filter Media (mg/kg)         800          800            800
    Orthophosphate Content of Filter Media
                                                  55           55             55
                    (mg/kg)
          Exfiltration Rate (mm/hr)               0.0          0.0            0.0
              Overflow Weir (m)                   2.0          2.0            2.0

2.4.3 EnviroPod
The EnviroPod is a proven gully pit insert designed to be easily retrofitted into new
and existing stormwater gullypits, requiring no construction or land take. It removes
a significant portion of sediment, trash, debris and other pollutants from water
entering the stormwater system, and can be installed in either curb inlet, standard
pre-cast gully pits or manhole gully pits.
It is proposed to install a total of six (6) EnviroPods within the development, with
Catchments A1 and A2 both having three each.

2.4.4 StormFilter
The StormFilter, a passive, flow-through, stormwater filtration system, improves the
quality of stormwater runoff from the urban environment before it enters receiving
waterways by removing nonpoint source pollutants, including sediment (TSS), oil and
grease, soluble metals, nutrients, organics, and trash and debris. The StormFilter has
been used to treat runoff from a wide variety of sites including, but not limited to:
retail and commercial developments, residential streets, urban roadways, freeways,
and industrial sites. StormFilters proposed within this development are outlined
within Table 10.
Table 10: StormFilter Requirements

           Catchment        Cartridge Size      Amount         Manhole Size
               A1               690mm             19                3100mm
               A2               690mm             19                3100mm
               E                430mm              7                1800mm
               F                430mm              7                1800mm

Both the EnviroPod and StormFilter have been setup as per the “SW360-MUSIC-
Modelling-Guidelines-2009” and reviewed by Stormwater360.



                                                                                         11
Log in to download the original file

Engineering_Integrated Water Management Plan.pdf · 6.9 MB (large file)

Large file: the download may take up to a minute.

Searchable page text hides email addresses. Original files are unchanged and may show email addresses.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.