Skip to the record
For the highest quality transcripts.

Original source · versioned page text

Development Application part 2 OF 2 All of CD, Information in notes - MCU12/0216

of 389

Page text shows just the words. Original shows the document exactly as it was published.

Page text read automatically using OCR, there may be inaccuracies

Very large file: it may take a few minutes

The original of this document is very large (36.8 MB). Opening the original or downloading it may take a few minutes. Please be patient and don't click again. The page text is quick to read. If you are on mobile data, it is best to wait until you are on Wi-Fi.

Original PDF page 139, section 1. The text section number identifies this passage in the reader.

 

152°54'30"E

 

152°55’00"E

152°55'30"E

 

  

|

 

26°23'00"

26°23'00"S

 

26°23'30"

 

 

 

 

26°23'30"S

yoy ROAD

 

 

 

 

152°54'30”

152°55’00”

152°55'30”

 

 

N Selected Land Parcel

Storm Tide Inundation Area
(including projected climate change impacts to 2100)

|| High hazard area (greater than 1.0m water depth)
Medium hazard area (less than 1.0m water depth)

Coastal Management District

Coastal Zone

Coastal Hazard Areas Map

Storm Tide Inundation Area
Requested By: [email protected]
Date: 12 Mar 12 Time: 13.22.15

Centered on Lot on Plan:
3 SP108094

Queensland
Government

 

LOCALITY DIAGRAM

 

 

 

 

2 100 200 300 400 500m

This scale bar is approximate only
Horizontal Datum: Geocentric Datum of Australia 1994 (GDA94)

This product is unprojected and is not suitable for measuring distances

1. A default storm tide inundation level of 1.5 m HAT in South East
Queensland regional planning area and 2.0 m HAT for the
remainder of Queensland is used where storm tide inundation levels
including climate change have not been determined locally. The
default level uses a sea level rise factor of 0.8m to 2100.

2. The high hazard area may be subject to permanent inundation
by sea level rise - refer to the Erosion Prone Area map.

3. The map should be used as a guide only. Field surveys are
recommended to verify feature boundaries.

Whilst every care is taken to ensure the accuracy of this product,

the Department of Environment and Resource Management makes
no representations or warranties about its accuracy, reliability,
completeness or suitability for any particular purpose and disclaims

all responsibility and all liability (including without limitation,

liability in negligence) for all expenses, losses, damages (including
indirect or consequential damage) and costs which you may incur as a
result of the product being inaccurate or incomplete in any way and

for any reason. This map is intended to be printed on an A4 page.

© The State of Queensland, 2012

 

 
Log in to download the original file

Development Application part 2 OF 2 All of CD, Information in notes - MCU12_0216.pdf · 36.8 MB (very large file)

Very large file: the download may take a few minutes. If you are on mobile data, it is best to wait until you are on Wi-Fi.

Searchable page text hides email addresses. Original files are unchanged and may show email addresses.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.