Original source · versioned page text
Bushfire Hazard Assessment and Management Plan
Original PDF page 24, section 1. The text section number identifies this passage in the reader.
This document appears to be plans or drawings. Its page text below holds only the words printed on the drawings, without the drawings themselves, so it may be jumbled or hard to follow. To see the plans as drawn, choose Original above or download the file (both need you to log in).
Log in to see the plans as drawn Bushfire Hazard Assessment and Management Plan
Section 4.2.6 of the QFES BRC technical guide provides a series of mapping rules (‘patch and corridor
filtering’) for modifying the potential fireline intensity of bushfire-prone areas to reflect the likelihood of
lower potential fireline intensities in smaller vegetation patches and narrow vegetated corridors. These
rules are applied as follows:
1. Remove patches of continuous fuel < 1 ha in area that are surrounded by either no fuel or non-
continuous fuel and are further than 100 m from any other continuous fuel greater than 2 ha;
2. Downgrade the effective fuel load of small patches of continuous fuel measuring a. 1 – 2 ha –
downgrade by 66% and b. 2 – 3 ha – downgrade by 50 % if the patch is surrounded by either
non-continuous fuel or a low-hazard vegetation or land-use type and if the patch is further than
100m from any other continuous -fuel vegetation patch greater than 2 ha; and
3. Remove narrow corridors and area of continuous fuel that are less than 50 m in width.
Based on the results of the site-specific assessment, vegetation within the assessment area does not
meet any of the patch and corridor filtering rules outlined in the BRC Technical Guide.
The potential fireline intensity was calculated for bushfire-prone vegetation within 150 m of the site using
the inputs from Steps 1 - 3. In accordance with Section 7.6 of the BRC Technical Guide, fireline intensity,
radiant heat flux and bushfire attack level is not required to be calculated for non-bushfire prone (i.e.
VHCs with a prone type of 2) or low hazard VHCs (i.e. VHCs with a prone-type of 3), therefore VHCs
39.2 and 40.4 have been excluded from calculation of potential fireline intensity. Remodelled potential
fireline intensity for bushfire-prone vegetation to the east and south/south-west of the site is provided in
Table 4.
Table 4: Potential fireline intensity for classified VHCs within 150 m assessment area
Location of Effective slope –
classified average slope
Fire Potential Potential
vegetation in beneath bushfire-
weather fireline bushfire
relative to VHC Status prone vegetation in
severity intensity hazard
development relation to
(FFDI) (PFI) class
area development
(degrees)
72,080
E 9.1 Remnant 21.3 Downslope 47 Very high
kW/m
82,746
S/SW 9.1 Remnant 22.8 Downslope 47 Very high
kW/m
The results of the potential fireline intensity calculation for bushfire-prone vegetation within the
assessment area show that vegetation associated with the eucalypt forest to the east and south/south
west of site (VHC 9.1) have a potential bushfire hazard class of ‘very high’. All other vegetation within
PR22116_BHAMP_178 Davis Rd, Cootharaba Page 19
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalLarge file: the download may take up to a minute.
Searchable page text hides email addresses. Original files are unchanged and may show email addresses.