Council archive · source document
22441 DA - Approved Plans [As Published] · 132001.210331.2
Plans and drawings: the text below has words only, no drawings.
x e REAL PROPERTY DESCRIPTION Lot 55 on RP 52918 Parish: WEYBA 10 Park Road, NOOSA HEADS Q. GENERAL NOTES Toilet doors are to open outwards or be fitted with lift off hinges in accordance with part 3.8.3.3 of BCA Housing Provisions. All glazing in buildings to comply with the requirements of part 3.6 of BCA2006 Housing Provision and AS1288/2005. A glazing certificate from the manufacturer for compliance with AS1288 must be provided on completion. Where existing crossover is modified the builder shall construct Kerb & Channel to match adjacent and to local authority requirements. All Balustrading to Decks shall be engineer certified. Builder to allow for disposal from site all waste materials during demolition and construction period. Smoke alarms must comply with AS 3786 and be connected to the consumer mains power. Smoke alarms must be located in accordance with part 3.7.2.3 of the building code of Australia. SUBTERRAIN J ~S GARAGE UNDER anes” NL a> ING LION fall > TANKING OF HABITABLE AREAS All steps in floors where retaining walls have been installed or where retaining walls are used as extemal walls of habitable rooms are to be waterproofed by an approved tanking system and installed by an accredited installer. The approved system is to be certified for compliance upon completion. EXCAVATIONS Sheet Piling to be designed and certified by RPEQ so as to support likely imposed loads and Not cause or allow damage to adjacent building works or land. All boundary works, including temp. works not to encroach over boundary. Builder to make allowance to prop, shore and retain the sides of all excavations required for building construction, The builder shall satisfy himself as to employ prior to commencing ‘any’ excavation. Any slippage or damage caused as a result of excavation shall be made good by builder. Adequate retention methods are the full responsibility of the builder. (1 SITE PLAN \wo.101) ‘SCALE1:200 @ A2 SURFACE WATER DRAINAGE The ground beneath suspended floors must be graded so that the area beneath the building is above the adjacent extemal finished ground level and surface water is prevented from ponding under the building. Refer figure 3.1.2.3 of BCA 2007 Housing Provisions. The extemal finished ground level surrounding the building must be graded to a slope not less than 50mm over the first 1.0m from the building in accordance with Figure 3,1.2.2 of BCA 2007 Housing Provisions. The finished ground level is to be a minimum of 150mm below ground floor level. BUILDING WORKS SETOUT Building Works to be setout by Licensed Surveyor. Identification and height verification survey to be cartied out once fascia/gutter and ridge to roof has been erected to confirm no works encroach boundaries and the building has been constructed in accordance with approved plans and height does not exceed 9.0m height limit as per the local planning scheme. FLOOR AREAS ENERGY EFFICIENCY 2 KT DWE/LV 713° REQUIREMENT BED 2 25 08m? Pro Therm “Reflecta Cell" 7mm insulation to be BED3 25.08m? installed to all roof spaces (excluding decks) to by TOTAL 146.54m? manufacturers direction. ; SITE COVER Pro Therm "Reflecta Shield’ 4mm insulation to TERMITE PROTECTION TERMITE PROTECTION The building shall be protected from subterranean termites by approved physical and/ or chemical bariers in accordance with AS3660.1. The precise method of protection shall be determined by the owner/ s and/ or builder only after consultation with a licensed pest contro! operator. This information then shall be advised to the Local Government or Licensed Certifier prior to, or at the time of lodgement of the Building Permit Application. Thereafter, the owners shall ensure that any physical barriers are kept clear of garden beds and/ or soil build up, that any chemical barriers remain undisturbed and that annual inspections (plus eradication as necessary ) are carried out thoughout the life of the building by a licensed pest control operator in accordance with AS3660.1. On the completion of the building prior to the final inspection by the licensed Building Certifier, a licensed Pest Controller is to inspect and confirm that the termite system installed has not been bridged or breached and the required visual barrier has been maintained. be installed to all exterior framed walls and framed floors in accordance with manufacturer's direction All external doors and windows to be fitted with a seal to restrict air infiltration Hot water systems shall be fitted with a heat trap within one metre of the outlet of the heater and before the first branch. All exhaust fans to conditioned spaces to be fitted with a self closing damper. SUB-FLOOR VENTILATION Note: The subfloor space beneath the suspended floor of a building must be designed and constructed in accordance with Part 3.4.1.2 of BCA 2007 Housing Provisions. WATER SUPPLY Water Supply: Connect to estate mains in accordance with development approval and local authority requirements If mains water pressure exceeds or could exceed 500kPa, a water pressure limiting device shail be installed to ensure that the maximum operating pressure at any outlet within the boundaries of the property does not exceed 500 kPa. WATER PROOFING WET AREAS Waterproofing of wet areas to comply with AS3740-2004. A certificate including bathrooms, WC and laundry from an approved waterproofing applicator will be required before a_ final certificate can be issued. STORMWATER Roof & surface stormwater to be disposed of in accordance with local authority requirements BUILDING WORKS SETOUT Building Works to be setout by Licensed Surveyor. identification and height verification survey to be carried out once fascia/gutter and ridge to roof has been erected to confirm no works encroach boundaries and the building has been constructed in accordance with approved plans and height does not exceed 9.0m maximum height limit SEWERAGE Connection of house drains to sewer main to be carried out in accordance with local authority requirements ARCHITECTURAL DRAWING SET 100 series dwg's - SITE PLANS WD 101 - Cover Sheet / General Notes WD 102 - Site Setout / Perspectives 200 series dwg's - PLANS WD 201 - Sub Floor Basment Plan WO 202 - Lift Landing Plan WD 203 - Main Floor Plan WD 204 - First Floor Plan WD 205 - Second Floor Plan 300 series dwg's - CEILING PLANS WD 301 -Main / First & Second Floor Plans 400 series dwg's - ELECT PLANS WD 401 - Sub Floor Basement Plan and notes WD 402 - Main / First & Second Floor Plans 500 series dwg's - ELEVATIONS WD 501 - North and East elevation WD 502 - South elevation WD 503 - West elevation 600 series dwg's - SECTIONS WD 601.- Sections A 700 series dwg's - DETAILS WO 701 - Details Sheet 1 WD 702 - Details Sheet 2 800 series dwg's - JOINERY WD 801 - Kitchen Details WO 802 - Kitchen and Laundry PLAN WD 803 - Ensuite 1 and 3 WD 804 - Bed 1,2 & 3 + Robes WD 805 - Ensuite 2 900 - series - SCHEDULESpat WD 901 - Window Schedule WD 902 - Door Schedule WALL & FLOOR LEGEND &zzz4 RC Block C“ Reinforced Concrete <== Timber Framed Wall fizz Finished Floor Level generally s3s09 Structural Floor Level generally +s.350 Spot Level r3s0 Reduced Level tow3s00 Top of Wall level SIGNATURE: kidd +CO designers 20 Duke Steet ‘Sunshine Beach QLD 4567 PO Box 262 Noosa Heads QLD 4567 07 5447 5633 07 5447 5833 Telephone Facsimile info@kiddeo com. au www kidd0o.comn. bu Tisdravngie obo readin conncton wih Engneors Drawgs & NOOSA CUTE PAPC oA eVeD HVaw.O}..,,., T1 PRICING ISSUE 6807 T2 ISSUE 20.00.07 Redocalion of = fit shat = driveway and relaining wals = tumtable + i shaft roof height raised 13 ISSUE 09.10.07 Development approval issue oe Projeot TREE HOUSE Location 10 PARK ROAD NOOSA HEADS Clack FIRST PICKED PTY Drawing Tide SITE PLAN Sede Dae as shown JAN 07 (Orawn By dob No, SF 0703 Oraweng No. teu Ko. WD.101 @)
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalUsed in these records
22441 DA - Approved Plans [As Published]Related documentApplication case desk ↗
About this file
- File size
- 1.0 MB (small file)
- File type
No other editions are linked here.