Reference Document - Geotech Report 132001.210327.1

                                                                                                                        ABN 51 640 311 842
                                                                                                                                  CONTACT
                                                                                                                          arcosgroup.com.au
                                                                                                                                   OFFICES
                                                                                                      Sunshine Coast | Brisbane | Gold Coast




            3 FIELDWORK METHODS
            The fieldwork for the investigation was undertaken on 19 August 2024 and included the following:
            •    Three (3) bores drilled and sampled in accessible locations to various depths utilising hand-held auger
                 equipment; and
            •    A dynamic cone penetrometer (DCP) test was undertaken at surface level at each bore.
            A suitably experienced and qualified geotechnician was present during the fieldwork to carry out site
            assessments, perform insitu testing and to log the encountered subsurface conditions through observation of
            drilling and excavation techniques, returned cuttings, and anecdotal evidence provided by drilling staff.



            4 FIELDWORK RESULTS
            The subsurface conditions encountered in the bores are described in detail on the log sheets in Appendix C,
            together with accompanying notes in Appendix A which define the classification methods and descriptive terms
            used. The depths were measured below existing surface levels at the time of investigation.
            The subsurface conditions encountered on site can be broadly categorised in Table 1.
            TABLE 1: SUMMARY OF SUBSURFACE CONDITIONS

             Material                            Information

             SAND                                The site can be characterised as comprising dune sand. The sand is very loose
                                                 initially, grading medium dense below approximately 2 m depth. The medium dense
                                                 sand is the target stratum for footings.



            No groundwater seepage was encountered in the bores at the time of investigation; However, given the nature
            of the subsurface conditions, it is paramount to give consideration to how groundwater levels can fluctuate
            with time and are transient in nature and how they could be perched or how they could be introduced from
            foreign sources (such as broken water infrastructure).



            5 COMMENTS
            5.1 EARTHWORKS COMMENTS
            Prior to any construction at the site, any deleterious materials and vegetation, should be stripped from within
            building envelopes.
            During construction, some loosening of the surface sands in excavations is expected. Therefore, the base of
            any excavation should be soaked and re-compacted using a vibratory plate compactor prior to constructing
            any footings/slabs. Confirmation of adequate compaction of sands could be obtained by carrying out DCP
            tests to achieve the above target value.
            If filling is required, it is recommended that sand at this site and imported fill be placed in loose lift thickness of
            not more than 200 mm, within 2% of optimum moisture content, and with each layer compacted to achieve not
            less than 8 blows per 300 mm rod penetration to a depth of 1.0 m, when using a DCP.
            Imported fill, if required, should comprise free draining cohesionless sand with less than 5% by weight of
            particles passing a 0.075 mm sieve. The material should be free from organic matter and large particles.




                                                                                                                                    Page 6


Document Set ID: 23245591
Version: 1, Version Date: 16/09/2024