250722 Minor Change Request · 132004.240022.3

      Condition 3.1
      The developer shall provide a minimum of 174 parking bays (with a maximum of 22 bays in
      tandem configuration) and 3 loading bays on site. Each car parking space shall not be less than
      5. 5 metres in length and not less than 2.6 metres in clear width. Parking bay dimensions are
      to be in accordance with the above, unless otherwise supported in writing by an RPEQ.

      Aisle widths are desirable 6.5m width but shall not be less than 6.0metres as detailed, on
      Council’ s Standard Drawing No. 9515. For blind aisles an aisle extension of 2m is to be
      provided to permit vehicle manoeuvre out of the end bays. Extra width is required on the end
      bay adjoining a blind aisle. Aisle widths are to be in accordance with the above, unless
      otherwise supported in writing by an RPEQ.

      Areas on which vehicles will be driven and/or parked are to be provided with a flexible or other
      pavement surfaced with bitumen seal coat, asphaltic or other concrete properly constructed and
      maintained to good engineering standards to the satisfaction of the Council’s Engineer. Plans
      and specifications for such areas including footpath crossings are to be submitted for approval
      prior to issue of a Building Permit. Vehicular access to and from the site is to be designed so as
      to ensure that sufficient area is available for manoeuvring and turning to permit forward
      movement to and from the road.

      The entrance to the car park shall have a minimum clearance of 2.1m as defined in Australian
      Standard A.S. 2890.1-1986 Car Parking Facilities. Allowance shall be made for required height
      of service vehicles, where applicable.

      The car park shall be available for use by members of the public. Signposting shall be provided
      in accordance with the requirements of the Shire Engineer at the access point. Parking spaces
      available for public use inside the building shall be clearly marked. Car Park entry may be
      subject to payment of a fee.


    In accordance with the above, we confirm that the change proposed is a minor change as outlined
    in Section 81 of the Planning Act 2016 and requires amendments to the approved plans and
    conditions.

    Please find attached a copy of the Planning Act Form for your records.

    We trust that the supplied information is sufficient for Council to address this matter.

    In the event that you do require clarification, or any further information please do not hesitate to
    contact the undersigned on (07) 3846 0807.

    Yours faithfully,
    Plan A Town Planning Pty Ltd




    Georgina McNee
    Senior Town Planner




Plan A Town Planning Pty Ltd              4/134 Constance St, Fortitude Valley Q 4006   p 07 3846 0807          abn 17 634 960 937
Town Planning & Development Consultants   PO Box 13 Fortitude Valley Q 4006             e [email protected]   www.planatownplanning.com.au