Skip to the record
Every meeting, every word.

Council archive · source document

Attachment 13- Amended Flood Study MCU12/0208

of 130

Text shows just the words. Original shows the document exactly as it was published.

Check the original when the exact wording matters.

Very large file (37.1 MB): the whole original can take several minutes to open, especially on a phone. Text is quick to read.

Original PDF page 16, section 1. The text section number identifies this passage in the reader.

Noosa on Weyba
Flood Study




4                      Hydrologic Model
4.1                    Rational Method
4.1.1                  Sub-catchments
The catchment areas were delineated using a combination of LiDAR data from DEHP, the digital 25 metre
grid DTM of South-East Queensland provided by DEHP and the catchment boundaries used in the Noosa
River Flood Study. The resultant sub-catchments are shown in Figure 1. The delineation of the Eenie
Creek and Keyser Creek tributaries of Lake Weyba was much more detailed than that conducted for the
regional flood study, and so comparison of the resultant peak flows from these catchments is not
appropriate.

4.1.2                  Times of Concentration
The times of concentration were calculated at several points for different tributaries using the Bransby
William’s Equation, which is the preferred method of QUDM (2007) for rural catchments less than 500
hectares. A summary of the calculations is shown below in Table 4-1. The total time of concentration for the
two creeks draining towards Lake Weyba was around 3 hours.
Table 4-1              Bransby Williams Time of Concentration Calculations

        Sub-                 Contributing    Stream Length     Equal Area       Tc
     catchment                Catchment           (km)           Slope         (min)
                                 Area                             (%)
                                 (ha)
        EC_A2                   230.29           2.53              1.54        78.1
        EC_B2                   349.48           4.44              3.62        110.8
        EC_C1                   72.48            2.08              1.89        69.0
        EC_E4                   285.22           2.50              1.34        77.6
        EC_F6                   76.58            1.41              1.53        48.8
        KC_I2                   139.68           1.75              1.65        56.1
        KC_H2                   246.54           2.49              1.31        79.0
  All catchments               1643.33           7.58              2.64        172.7
    draining to
   Eenie Creek
   and Keyser
       Creek



4.1.3                  Rainfall Intensity
The rainfall intensities were taken from Noosa using AUSIFD. The resultant rainfall intensities are shown in
Appendix C.

4.1.4                  Fraction Impervious
The fraction impervious values for the sub-catchments were taken from the values used for the Noosa River
Flood Study. The lake was assumed to be fully impervious.

4.1.5                  Runoff Coefficient
The runoff coefficient for each sub-catchment was calculated from QUDM. Based on the rainfall intensity a
10 year runoff co-efficient for fully pervious areas of 0.70 was adopted.




Northbrook Corporation Pty Ltd                            Version 4                         16 September 2013
Flood Study v4 2.doc                                Commercial in Confidence                         Page 11

Used in these records

About this file

File size
37.1 MB (very large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

Attachment 13- Amended Flood Study MCU12_0208.pdf · 37.1 MB (very large file)

The download may take a few minutes. On mobile data, it is best to wait for Wi-Fi.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.