Council archive · source document
Geotech Report Reference Document OPW19-0239 · OPW19/0239
Very large file (10.7 MB): the original may take a few minutes to open or download. The page text below is quick to read.
Gympie Terrace Noosaville Pty Ltd
The field pH result (pH 5.4) indicates that the groundwater is slightly acidic. The measured electrical
conductivity (EC) value of 1.5 mS/cm indicates that the groundwater is brackish.
Dissolved iron and aluminium concentrations are low. Total iron and aluminium concentrations recorded
were consistent with other sites located along the coastal areas of Southeast Queensland.
C1.3 Preliminary Screening
Results of preliminary screening are summarised in Table C1. Soil pH (represented by pHF results) was
found to range between pH 5.1 and pH 6.9 (moderately acidic to slightly acidic). The pHFOX ranged from
pH 2.2 to pH 4.6, suggesting a generally moderate to high potential for the presence of PASS.
C1.4 Quantitative Soils Analysis
Table C3 below shows the ASS action levels adopted in Queensland. These categories are used to identify
whether action / management of ASS spoil is required, based on ‘net acidity’. Action criterion of 0.03% S
equivalents (18 moles/tonne) was adopted for this investigation.
Results of the 12 samples analysed are summarised as follows:
No samples returned Titratable Actual Acidity (TAA) results above the action criteria of 18 mol H+/
tonne (0.03% S).
Nine samples returned Oxidisable Sulfur as SCR at levels above the action criteria of 0.03% S.
No samples returned a pH-KCl value exceeding pH 6.5, therefore were not tested for acid
neutralising capacity (ANC).
No samples returned pH-KCl values of less than or equal to pH 4.5, therefore were not tested for
retained acidity (SNAS).
Table C3: ASS Action Criteria.
Action Criteria
Action Criteria
> 1000 tonnes disturbed
Type of Material 1-1000 tonnes disturbed
(and major fill projects)
Existing + Potential Acidity Existing + Potential Acidity
Equivalent sulfur Equivalent acid
Texture range Approx. clay Equivalent sulfur Equivalent acid
%S oxidisable mol H+/ tonne
McDonald et al. (1990) content (%) %S oxidisable mol H+/ tonne
(oven-dry basis) (oven-dry basis)
Coarse Texture
≤5 0.03 18 0.03 18
Sands to loamy sands
Medium Texture
Sandy loams to light 5 – 40 0.06 36 0.03 18
clays
Fine Texture
Medium to heavy clays ≥40 0.10 62 0.03 18
and silty clays
J000799-002-R-Rev0 Page 16
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalUsed in these records
Geotech Report Reference Document OPW19-0239.pdfRelated documentApplication case desk ↗
About this file
- File size
- 10.7 MB (very large file)
- File type
No other editions are linked here.
Original file
Log in to download the original file
The download may take a few minutes. On mobile data, it is best to wait for Wi-Fi.