Skip to the record
Beware of cheap imitations.

Original source · versioned page text

2111-25917 SRA - Response with conditions

Attached to the e-mail SARA Referral agency response – with conditions - MCU21/0192.

of 6

Page text shows just the words. Original shows the document exactly as it was published.

                                                                                        2111-25917 SRA




Attachment 3—Reasons for referral agency response
(Given under section 56(7) of the Planning Act 2016)

The reasons for SARA decision are:

   The proposed development is for a material change of use for a dual occupancy.
   The subject site is located in an area with substantial unexploded ordnance potential.
   SARA assessed the development application against State code 13: Unexploded Ordnance of the
    State Development Assessment Provisions (SDAP), version 2.6, and determined that with a
    condition, the development achieves compliance with the performance outcomes of the state code.

Material used in the assessment of the application:

   The development application material and submitted plans
   Planning Act 2016
   Planning Regulation 2017
   The State Development Assessment Provisions (version 2.6), as published by the department
   The Development Assessment Rules
   SARA DA Mapping system
   State Planning Policy mapping system
   Human Rights Act 2019




State Assessment and Referral Agency                                                       Page 5 of 6
Log in to download the original file

2111-25917 SRA - Response with conditions.pdf · 229 KB (small file)

Searchable page text hides email addresses. Original files are unchanged and may show email addresses.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.