Skip to the record
NoosaWatch™: The source of truth.

Original source · versioned page text

2017-11-07 P&E Committee - Attachment 1 to Item 1 - Amendments for Multiple Housing Type 2 Duplex & Minor Corrections

of 862

Page text shows just the words. Original shows the document exactly as it was published.

                               b. the probable solutions complies with the overall and specific outcomes of
                                   the code;




                                                                                                                          Including amendments to 3 July 2017
                                                                                                              The Noosa Plan
                     iv.      is to be assessed against any assessment benchmarks for the development
                              identified in section 26 of the Planning Regulation 2017.
         Editor’s note—section 27 of the Regulation identifies the matters code assessment must have
         regard to.

        e)    Impact assessable development:

               i.          is to be assessed against the identified assessment benchmarks in the
                           assessment benchmarks column (where relevant);

              ii.      assessment is to have regard to the whole of the planning scheme, to the extent
                       relevant;

              iii.     is to be assessed against any assessment benchmarks for the development
                       identified in section 30 of the Planning Regulation 2017.
         Note—The first row of each table of assessment is to be checked to confirm if there are
         assessment benchmarks that commonly apply to general scenarios in the zone, local plan or
         overlay.

         Editor’s note—Section 31 of the Regulation identifies the matters that impact assessment must
         have regard to.

2.6.5    Despite sections 2.5.1 and 2.6.4, where premises are identified with the Notation “Refer
         to Schedule 6” on a Zoning Map ZM1—ZM9, these premises are specified in Column 1
         and 2 of Table 6-1 of Schedule 6.

2.6.6    A material change of use identified in Column 3 of Table 6-1 of Schedule 6 that complies
         with the conditions of approval and the approved plan of development for that premises is
         accepted development subject to requirements; or

2.6.7    If the approved plan of development contains a supplementary table of development or
         otherwise identifies levels of assessment, a material change of use identified in Column 3
         of Table 6-1 of Schedule 6 has the assessment level nominated by the approved plan of
         development.

2.6.8    A material change of use for a use identified in Column 3 of Table 6-1 of Schedule 6 must
         comply with any applicable codes identified in Column 4 of Table 6-1 of Schedule 6.

2.6.9    Notwithstanding the provisions of this section the Queensland State Planning Policy
         includes as Part E, interim development assessment requirements to ensure that State
         Interests are appropriately considered in development assessment. Interim development
         assessment requirements are contained within the State Planning Policy and address the
         following State Interests:

         a)          Liveable Communities

         b)          Mining and Extractive Resources

         c)          Biodiversity

         d)          Coastal Environment

         e)          Water Quality

         f)          Emissions and Hazardous Activities

         g)          Natural hazards, risk and resilience


                                                         2-7
Log in to download the original file

2017-11-07 P&E Committee - Attachment 1 to Item 1 - Amendments for Multiple Housing Type 2 Duplex & Minor Corrections(PDF, 9MB).pdf · 9.9 MB (large file)

Large file: the download may take up to a minute.

Searchable page text hides email addresses. Original files are unchanged and may show email addresses.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.