Skip to the record
Every meeting, every word.

Original source · versioned page text

Representations

of 3

Page text shows just the words. Original shows the document exactly as it was published.

Our Ref: 20210417
Council Ref: MCU21/0170


8 March 2022

        Noosa Council
        PO Box 141
        Tewantin QLD 4565
        Via email: [email protected]

        Attention: Maxwell Potter


Dear Max,

REPRESENTATIONS - DEVELOPMENT PERMIT FOR A MATERIAL CHANGE OF
USE (DUAL OCCUPANCY) AT 183 WEYBA ROAD, NOOSAVILLE (LOT 8 ON
RP113358)

Further to the Council’s Decision Notice issued on 24 February 2022 for the above development
application, and pursuant to Section 75 of the Planning Act 2016, we now make the following
representations in regards to Council’s approval.

Any proposed wording to be removed will be struck through. Any new wording will be included in bold.

CONDITIONS OF APPROVAL

Condition 13

In accordance with AO17.3 of the Medium Density Residential zone code, solid front fences and walls may
be 1.8 metres in height if the property has frontage to an arterial road or a distributor road. Weyba Road
is classified as a distributor road, hence the proposed fence height and finishes are considered
acceptable.

Gates are transparent to allow for casual surveillance of the street and public areas, whilst providing
security to residents. A landscape strip ranging from 1m-1.2m is provided in front of the fence to soften
the built form.

As such, we request that Condition 13 is amended as follows:

        13. Any street fencing must be set back an average of 1 metre from the front property
        boundary. Any fencing on the front boundary must either: a. not exceed a maximum
        height of 1.2m 1.8m.
        b. be of open construction.
Log in to download the original file

Representations.pdf · 278 KB (small file)

Searchable page text hides email addresses. Original files are unchanged and may show email addresses.

Full text of the other 2 pages

Page 2

Condition 16(f) and (g)

Queensland Development Code MP1.3 states:

        “...Swimming pools may be within the boundary clearances nominated in A2(a) and (b) where -
                (i) a solid wall or fence, constructed to prevent water entry onto adjoining lots, at least
                1.8m high above finished ground level, is erected between the swimming pool and the
                boundary of the lot; and
                (ii) the top of the wall or fence is at least 1.0m above the top of the coping of the pool…”

Drawing A.05.01 (TP4) Building Sections Plan prepared by Hive Architecture confirms that the proposal
can achieve a 1.8m high solid wall to prevent water entry onto adjoining lots, and the top of the fence is
at least 1m above the top of the coping of the pool. Refer to Figure 1 below.




                   Figure 1: Extract of rear fence height adjoining pool (Hive Architect Plans)

As such, we request that Condition 16 is amended as follows:

16. The development site must be landscaped. The works must be undertaken in accordance with an
Operational Works approval and the Noosa Plan and in particular the Noosa Plan - PSP2 – Landscaping
Planning Scheme Policy for that specific area and must include in particular:

        a. a minimum one (1) metre wide landscaping strip between the fence and the front property
        boundary along the Weyba road frontage of the subject site, exclusive of the access driveway,
        generally uncompromised by infrastructure items;




                                                                                                          2

Page 3

        b. a minimum 800mm wide landscaped garden to be located on the inside of the front boundary
        fence, exclusive of the access driveway, generally uncompromised by infrastructure items;
        c. The front boundary landscaping outside and inside of the fence must be densely planted with
        understorey and taller species to screen the fencing and building from the street with plants
        selected to grow to a minimum mature height of 1.5m and be planted at maximum 1.5m centres;
        d. The front boundary landscaping must include at least two feature trees with a 45 litre pot size
        minimum.
        e. A minimum one metre wide garden to the eastern and western boundary fences must be
        densely landscaped. Screening plant species must be planted at a maximum of 1.5m centres and
        have a 200mm pot size. The screening trees must grow to a minimum mature height of 4m along
        the entire length.
        f. All pools must be situated to allow for soft dense landscaping between the pool and fence for
        the length of the rear boundary.
        g. A minimum one metre wide garden to the southern boundary fence must be densely
        landscaped. Screening plant species are to be planted at a maximum of 1.5m centres and have a
        200mm pot size. The screening trees must grow to a minimum mature height of 4m along the
        entire length
        h. f. Provision of 1 x 45 litre pot size street tree within the road reserve for every 8 metres of
        road frontage.
        i. g. Provide a planting plan and plant schedule including species and pot size that meets the
        PSP2 – Landscaping Policy in particular plant species that are Noosa Native Preferred and meet
        the local character of the area.
        j. h. A minimum 0.6 metre wide garden to the eastern and western boundary fence must be
        densely landscaped. Screening plant species are to be planted at a maximum of 1.5m centres
        and have a 200mm pot size. The screening trees must grow to a minimum mature height of 4m
        along the entire length.

APPROVED PLANS

In light of the above, we request that the plan annotation ‘location of pools not approved’ be deleted.

Should you have any questions in relation to the above, please do not hesitate to contact the
undersigned.

Yours faithfully,
Adapt Development Management Pty Ltd




Tiani Boulton
Director
E: [email protected]
M: 0404 924 160




                                                                                                          3

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.