Skip to the record
The gold standard in government transparency.

Council archive · source document

1025JS.lp CDA app ltr · 132003.220735.8

of 5

Text shows just the words. Original shows the document exactly as it was published.

Check the original when the exact wording matters.

Sunshine Coast Office
| Innovation Parkway, Birtinya, PO Box 149,Wurtulla QLD Australia 4575
T +61 75436 7888 F +61 75493 6630 & [email protected] W rpsgroup.com.au

Our Ref: PR100133-5.1025JS.Ip

Council Ref: 152005. 170.05/ 432003. 220735.8 (23245 DA)
Date: 27 November 2013

Attn: Glen Conforti

Sunshine Coast Regional Council
Locked Bag 72
Sunshine Coast MC QLD 4560

Via Email ([email protected]) and Mail

Dear Glen

RE: REQUEST TO CHANGE DEVELOPMENT APPROVAL PURSUANT TO SECTIONS
369 AND 370 OF THE SUSTAINABLE PLANNING ACT 2009.
58 NOOSA SPRINGS DRIVE, NOOSA HEADS: LOT 506 SP261524 AND
INCLUDING FORMER LOT 1 SP161938 & LOT 2 RP904900.

We act behalf of AV Jennings Limited regarding the most recent Development Approvals granted
by Sunshine Coast Regional Council for the abovementioned land. These Development
Approvals are for the following aspects of development:

= Development Permit for a Material Change of Use to establish 93 dwelling houses and group
and group housing development of 96 dwelling units (Council Ref:132003.220735.8 (23245
DA) dated 19" May 2011; and

= Development Permit for, a Reconfiguration of a Lot — 189 Lots plus open space (Council Ref:
152005.170.05) dated 6" October 2011.

In accordance with Sections 369 and 370 of the Sustainable Planning Act 2009, we are making a
request to Sunshine Coast Regional Council under S369 (1) to make a change to the
development approval.

Approval of minor changes to the approved Master Plan No. 6994 -53N (Plan of Development
(POD)), by way of clarifying the meaning and intent of a number of the key development
requirements, is sought; reconfiguration of two of the proposed future lots (Lots 63 & 64) is also
proposed. As a consequence, changes to some of the Conditions of the abovementioned
Development Approvals will be required in order to reflect the correct number of the approved
plan. To this end, we have prepared a revised POD (Plan No. 6994-53P), comprising three (3)
sheets and reflecting the proposed changes; this plan, when approved, will supersede approved
Plan No. 6994-53N. A copy of the revised POD is enclosed as part of this submission.

A list of the requested changes is included below:

= It is proposed to include the word ‘optional’ before the words ‘Built to boundary line’ within the
‘Development Statistics’ legend to provide prospective purchasers with the option to have a
built-to-boundary wall on their lot, as shown on revised Plan No. 6994-53P (Sheet 1); this is
carried through to the two additional sheets, with the legend clearly showing that built to
boundary walls are optional;

=» Amendment to the ‘Supplementary Table of Development’ on the POD to allow for Detached
Dwellings to be Self Assessable; also, the inclusion of a new row within this table such that
Detached Dwellings that don’t comply with the key development requirements are to be
Code Assessable, as shown on revised Plan No. 6994-53P;

England | Wales | Scotland | Northern Ireland | Ireland | Netherlands | USA | Australia 1025J8.Ip Permissible Change Ltr

RPS Australia East Pty Ltd ABN 44 140 292 762 A member of the RPS Group Ple
Full text of the other 4 pages

Page 2

Page 2

PR100133-5.1025JS.Ip

« For clarification purposes, a new version of the ‘Key Development Requirements for
Precincts’ table is incorporated into the revised Plan No. 6994-53P and replaces the ‘Key
Development Requirements for Precincts’ table shown on previously-approved Plan No.
6994-53N;

= Two (2) new sheets have been added to the POD to show building envelopes, permitted
boundary setbacks and optional built-to-boundary walls. In addition, for built-to-boundary
walls, the opposite side boundary to the built-to-boundary wall boundary shall have a
minimum building setback of 3 metres;

= Built-to-boundary walls are now shown on lots less than 600m”, as shown on revised Plan
No. 6994-53P (Sheets 1 — 3) — these are optional, however,

= A change to the configuration of proposed Lots 63 and 64, by rotating their common
boundary approximately 90 degrees such that each lot is afforded two road frontages, has
been shown on the revised plan. The building envelope on each lot will then have 3.0 metre
setbacks to both road frontages and 1.5 metre side boundary setbacks. In addition, it is
proposed to include an additional dot point on the ‘Key Development Requirements for
Precincts’ table to enable Lots 63 and 64 to have garage access from the southern frontage
(Smoke Bush Drive) rather than the northern frontage (Hollyhock Crescent); and

= For consistency purposes, it proposed to amend a number of Conditions of Approval to
reference revised Plan No. 6994-53P

Background

As highlighted above, we are primarily seeking to change the Level of Assessment for Detached
Dwellings, as indicated on the ‘Supplementary Table of Development’, from Code Assessable to
Self Assessable, in order to remove the onerous, costly and time-consuming requirement for
prospective purchasers to obtain Council Approval for a Detached Dwelling in most cases.

However, we have also taken this opportunity to attend to a number of minor changes to the
POD which are required to clarify the wording of the ‘Key Development Requirements for
Precincts’ table. Moreover, it is proposed to change a number of Conditions of Approval to reflect
the revised Plan No. 6994-53P. Also, in the process of assessing the impact of the development
requirements, our client has decided that a better design outcome for the houses on two of the
future lots, Lots 63 & 64, will be afforded if these two lots are reconfigured.

The proposed changes are set out in further detail below. Please note, where changes are

required to certain words, the word to be amended is struck-out and replaced with the word in
bold font.

Proposed Changes
Supplementary Table of Development

The ‘Supplementary Table of Development’ currently reads as follows:

 

Development Level of
Assessment

Group Housing including ancillary recreational and allied community | Self Assessable

use facilities in private open space complying with the key requirements
contained on this plan

Detached Dwelling within a Group Housing Lot Code-Assessable
Self Assessable
Detached Houses within a Group Housing lot where not complying | Code Assessable
with the Key Development Requirements for the Precinct
Estate Sales Office Self Assessable

 

 

 

 

 

 

 

 

1025JS.Ip Permissible Change Ltr

Page 3

Page 3

PR100133-5.1025JS.Ip

Requested Change:

Amendments are proposed to the ‘Supplementary Table of Development’ to change the Level of
Assessment for Detached Dwellings from Code Assessable to Self Assessable. In addition, it is
proposed to include a new row within this table to allow for Detached Dwellings where not
complying with the key development requirements to be Code Assessable, as shown on revised
Plan No. 6994-53P (Sheet 1).

Key Development Requirements for Precincts table

It is recognised that the ‘Key Development Requirements for Precincts’ table shown on approved
Plan No. 6994-53N is not clear in several respects; it contains minor typographical errors and
requires updating for both administrative and clarification purposes.

We have therefore prepared a concise version of the ‘Key Development Requirements for
Precincts’ table as shown on revised Plan No. 6994-53P (Sheet 1), that replaces the ‘Key
Development Requirements for Precincts’ table shown on approved Plan No. 6994-53 N.

Plan of Development — Inclusion of Sheets 2- 3

It is proposed to include two (2) new sheets within the POD to show building envelopes,
permitted boundary setbacks and built-to-boundary walls. In addition, where built-to-boundary
walls are shown, the opposite side boundary to the built-to-boundary wall boundary shall have a
minimum building setback of 3.0 metres and this is shown on the updated plan sheets. This
requirement is also notated on the amended ‘Key Development Requirements for Precincts’
table under the ‘Built to the Boundary Walls and Side Setbacks’ heading.

Built- to- Boundary Walls for Lots less than 600m?

It is considered that built-to-boundary walls would be a suitable option for lots less than 600m’,
and would significantly improve the streetscape character. Built-to-boundary walls are therefore
provided for, as an option, on all lots less than 600m’.

Development Statistics

Itis proposed to include the word ‘Optional’ before the words ‘Built to boundary line’ in the legend
on the POD. Built-to-boundary walls are considered suitable on lots less than 600m? in area,
however, it is recognised that imposing a mandatory requirement for designated built-to-
boundary wall lots would not always be desirable and it is considered that offering prospective
purchasers this option is more appropriate.

Proposed Lots 63 and 64

Recent discussions with Council’s Planning Officer, Glen Conforti, around our client's request to
change the configuration of proposed Lots 63 and 64, by rotating their common boundary
approximately 90 degrees such that each lot would be afforded two road frontages, indicated that
Council would probably have no objection to such a proposal. The amended configuration of
these two lots is shown on the revised plan, with no other changes to the lot layout proposed.
The new building envelope for each lot allows for a 3.0m setback to both road frontages and a
4.5m side boundary setback in each case, this being consistent with setbacks adopted for other
lots in the development.

Moreover, as each lot will have two road frontages, it would seem to be Council’s preference that
garages gain access from the southern road (Smoke Bush Drive) rather than the northern road
(Hollyhock Crescent) for these two lots. Accordingly, an additional dot point under the ‘General’
heading in the ‘Key Development Requirements for Precincts’ table, specifically provides for this;
our proposed wording is as follows:

“Garage access to Lots 63 and 64 will be from each lot's southern frontage”

1025JS.Ip Permissible Change Ltr

Page 4

Page 4

PR100133-5.1025JS.Ip

Proposed Changes to Conditions

Development Approval dated 6" October 2011 (Council Ref: 153005.170.05) references two
previous approved versions of the Plan of Development; specifically, Condition 6 references
Plan 6994-53L.dwg dated 10 January 2008, while Conditions 9, 34, 38, 41, 44- 46, 66
reference Plan 6994-24D.dwg dated 29 September 2004. (The ‘24’ series of plans was
replaced by the ‘53’ series in 2006 and should no longer appear in any current approvals or
conditions.)

In addition, Development Approval dated igh May 2011 (Council Ref: 132003.220735.8 (23245
DA)) references Drawing No 6994-53N Revision N dated 4 April 2011 in Conditions 2, 12, 65,
81, 103, 121, 137, 144, 145, 155, 181.

We therefore request that the aforementioned Conditions be amended to reference revised
Plan No. 6994-53P in all cases.

Infrastructure Contributions

We also request that Condition 47 of Development Approval 153005.170.05, and Condition
158 of Development Approval 132003.220735.8 (23245 DA), be updated to reflect current
infrastructure contributions payable under Council's ‘Adopted Infrastructure Charges
Resolution (No. 4) 2011’.

Approved Plans/ Documents

The approved plans table in both Development Approvals should be updated to reference
revised Plan No. 6994-53P, instead of 53L or 53N.

Conclusion
In accordance with section 367 of the Sustainable Planning Act 2009, it is recognised that a
‘permissible change’ to a development approval, is defined as follows:

(1) A permissible change, for a development approval, is a change to the approval that
would not, because of the change—

(a) result in a substantially different development; or

(b) if the application for the approval were remade including the
change—
(i) require referral to additional concurrence agencies; or
(ii) for an approval for assessable development that previously

did not require impact assessment—require impact
assessment; or
(c) for an approval for assessable development that previously required
impact assessment—be likely, in the responsible entity’s opinion, to
cause a person to make a properly made submission objecting to the
proposed change, if the circumstances allowed; or
(d) cause development to which the approval relates to include any
prohibited development.

In light of the aforementioned definition, we confirm that if the application were to be remade it

would not result in referral to additional Concurrence Agencies, nor would the application be
subject to Impact Assessment.

1025JS.Ip Permissible Change Ltr

Page 5

Page 5

PR100133-5.1025JS.Ip

In support of this request, please find attached:

Updated Plan No. 6994-53P;

Council's completed Application Form;

Owner’s Consent Letter;

Cheque for the Council’s relevant fee of $2,303.00; and

Copy of correspondence sent to particular entities as required by Section 372.

We trust this information is sufficient for your purposes, however should you require any further

details or clarification, please contact me directly and we look forward to Council’s favourable
consideration of this application.

Yours faithfully
RPS

Jeremy Scriven
Principal — Survey

Enc. Plan No. 6994 -53 P
Application Form
Owners Consent
Cheque - $2,303.00
Correspondence under Section 372

1025JS.Ip Permissible Change Ltr

Used in these records

About this file

File size
3.8 MB (large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

1025JS.lp CDA app ltr.pdf · 3.8 MB (large file)

The download may take up to a minute.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.