Skip to the record
Mmm.. taste the original NoosaWatch™

Council archive · source document

Development Application IDAS Form 1 & 6 - OPW12/0439

of 26

Text shows just the words. Original shows the document exactly as it was published.

Check the original when the exact wording matters.

Very large file (12.7 MB): the original may take a few minutes to open or download. The page text below is quick to read.

012            FORMS ANO EQUIPMENT

               Before placing, all equipment for mixing and transporting the concrete shall be
               clean, debris shall be removed from that place to be occupied by the concrete, and
               forms shall be thoroughly wetted.          Forms shall conform to the shape, lines and
               dimensions of the concrete as called for in the Drawings. The surface of all forms
               in contact with      concrete   shall be    clean, and forms shall be substantial and
               sufficiently tight as will prevent leakage of mortar. Forms shall be supported and
               braced so that they will not deflect, distort or move out of position when concrete is

               placed and compacted.

               The Contractor shall have available              on   site and   operational   at   short notice,
               adjustable forms, vibrating screeds and associated equipment suitable to carry out
               the following work:


                  Complete concreting work by hand methods to an approved construction joint in
                  the event of machine failure.

                  Remedial work to any surface where a machine has not fmished concrete to a

                  satisfactory standard.


013            TOLERANCES

               Kerbs shall be within +3 mm in line and level from the positions shown on the

               Drawings and shall not deviate more than 3 mm from a 3 m straight edge.


014            CURING


               Exposed surfaces of concrete shall be kept constantly damp for the first seven days
               after placing.  Alternatively, curing compounds may be used subject to the
               agreement of the Superintendent.



015            JOINTING


015.1          Kerb, water tables, spoon drains and edge strips

               Shrinkage control joints shall be constructed by template for hand laid work using
               fixed form work. Joints shall be regularly spaced at 3 m intervals using a spacer or

               guillotine 3 mrn thick. A minimum of 50% of the area of the selection shall be cut.
               The resultant slot in the section shall be tooled to a depth of not less than 20 mm to

               produce a neat groove of less than 5 mm in width.

               Construction joints shall be created wherever the work of placing concrete is
               delayed until the concrete has taken its initial set. Joints shall be made during
               pouring and not saw cut after hardening.

               The construction joints shall be located at the nearest 3 m      shrinkage joint as
               specified above, and shall be avoided in entranceway inverts, pram inverts and radii
               at street corners.


               The construction joints shall be straight and           perpendicular to the kerb face and
               vertical in the kerbs and shall be tooled off to provide a neat groove.




AEVI07.201-TD-CV-SPC-OOOI Rev. A                          D-4

IOJllly 2012                                                                                       KBR

Used in these records

About this file

File size
12.7 MB (very large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

Development Application IDAS Form 1 & 6 - OPW12_0439.pdf · 12.7 MB (very large file)

The download may take a few minutes. On mobile data, it is best to wait for Wi-Fi.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.