response to information request - BDH Eumundi Noosa Rd

13 October 2021


Maxwell Potter
Noosa Council
[email protected]


RE:    Response to Information Request – MCU21/0145 – 170-174 Eumundi Noosa
       Rd, Noosaville


Council issued a further information request on 16 September 2021. The applicant
provides the following additional information in response to the items:

   1. Please provide clarification of whether any earthworks will be required to
      prepare the site for the construction of the development. If earthworks are
      required, please submit a conceptual plan that indicates the approximate
      volumes of cut and/or fill required.

Please find attached preliminary earthworks layout plan by Bornhorst & Ward Engineers.
The plan indicates cuts of 96.5m3 and 679m3 of fill (582m3 import fill, or ~20 truck and dog
loads). This allows for a finished floor level of 20.3m and a retaining wall up to 2m high
along the rear of the property.

    2. Please provide an amended plan that satisfies this requirement or
       alternatively provide justification why the above requirement cannot be
       fulfilled on the site.

The site is 2,096m2 and the development is proposed for a specific tyre and mechanical
tenant which uses a small. The design has catered for large landscaping areas along
Eumundi Noosa Rd and allows for the onsite manoeuvring for a 9.9m long Cleanaway
refuse vehicle and loading for larger vehicles.

There is sufficient space on the site for a 2 axle rigid truck to deliver and remove tyres
from the site – this is similar to other existing tyre refitting sites in Noosaville. The use of
larger vehicles >9.9m and <12.5m would occur outside regular business hours to take
advantage of the western carparking area for turning and manoeuvring. A condition is
recommended similar to other industrial developments in the Noosaville industrial area.

   3. Noting that side lift waste collection trucks do not service on private
      property, provide a detailed Waste Management Plan, which must include
      detail, but not be limited to the following:
         a. Number and type of bins to be collected;
         b. Location of where bins are to be collected;
         c. Demonstrate how stormwater will not enter the wash bin area;
         d. Provide details of the bin wash area’s connection to sewer
              infrastructure;
         e. Type of vehicle required for the collection;
         f. Provide travel paths for the required waste collection vehicle,
              demonstrating how it will manoeuvre on site without having to use
              more than a 3 point turn to turn around.

Please find attached a Waste Management Plan addressing the requirements of PSP9 –
Waste Management Plan.