Council archive · source document
Delegated Report - Code - Planning MCU24 0139 (As Published) · MCU24/0139
manufacturing, electronics software, material and textile science,
medical equipment, medical prosthetics and bionics, avionics,
neuroscience, and sports science technologies.
Science, research For research and development of block change and digital currency,
and technology Artificial Intelligence (AI), , robotics, and other emerging areas of
research, development, and technology.
Environmental Research into the conservation, prevention and control of global
industries food production and food security, small-scale renewable energy
research services and product development, climate change and
carbon trading with the development of understanding
environmental issues in a studio or office environment.
Education and Education and training where it is subordinate to one or more of the
training employment sectors identified in this Table.
Building Height
8. The maximum height of the development must not exceed 8.0 metres above the ground
level.
9. Certification must be submitted to Council from a Registered Cadastral Surveyor (Qld) which
certifies that the building does not exceed the maximum height requirement of this Decision
Notice.
Performance Bond
10. Security in the form of a cash bond or trading bank guarantee to the sum of $15,000 must
be submitted to Council, to secure performance of all conditions of this approval, prior to the
issue of a Development Permit for Operational Works. The cash bond or trading bank
guarantee will be returned on performance of the conditions of approval less any costs
incurred by Council in respect of enforcing performance of this permit. Council reserves the
right to call upon the bond or guaranteed sum to effect compliance with conditions.
Street Identification
11. The street address of the development must be clearly visible and discernible from the
primary frontage of the site by the provision of a street number and, where appropriate, the
building name.
Building Appearance
12. External design features, materials and finishes must be as shown on the Approved Plans,
with no inclusions or alterations made without approval in writing by Council.
13. External finishes of the building must be a mix of lightweight and textured external finishes,
with masonry areas incorporating a variety of textured finishes to break up the surface.
14. All deck and balcony areas must not be enclosed with shutters, louvres, glass panelling or
the like thus remaining as open structures.
15. All balustrades to decks and balcony areas must be open or transparent.
16. External colours and finishes must be of an understated colour scheme and low-reflective
roofing and cladding materials.
17. All mechanical equipment and other service infrastructure located on the site must be:
a. located not less than 2 metres from a property boundary
b. fully enclosed or screened such that they are not visible from the street frontages nor
adjoining properties. Where screened by landscaping, landscaping beds must be at
least 1.5 metres wide.
Page 18 of 25
Document Set ID: 23369912
Version: 4, Version Date: 21/07/2025
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalUsed in these records
Delegated Report - Code - Planning MCU24 0139 (As Published).pdfRelated documentApplication case desk ↗
About this file
- File size
- 3.0 MB (large file)
- File type
No other editions are linked here.
Original file
Log in to download the original file
The download may take up to a minute.