Original source · versioned page text
MCU18.0166 - Response to Information Request (amended)
1. Introduction 2.2. Assessment of representative
viewpoints
The purpose of this study is to provide a visual
impact assessment of the proposed National The assessment of visual impact would be
Broadband Network (NBN) monopole site (no. undertaken in the following steps:
4POM-51-45-CRNA) at 244 Tablelands Road, • Identify the sensitivity of the viewer
Cooran. (Refer table 2.1)
The proposal site is located approximately two
• Identify the level of modification created
kilometres northeast of the rural town of
by the project (Refer table 2.2)
Cooran in the Noosa region.
• Combine these characteristics to assign
a level of likely visual impact (Refer table
2. Methodology 2.3)
The following assessment considers the • Identify opportunities for mitigation to
potential visual influence of the proposal on the reduce the impact where possible.
surrounding landscape and an assessment of
views from these locations. Sensitivity refers to the susceptibility of a view to
accommodate change without losing valued
2.1. Zone of visual influence attributes. The valued attributes of a view refers
to any aspect of landscape or views people
This assessment begins with the identification of consider to be important. Visual values may be
a Zone of visual influence (ZVI). ZVI mapping has reflected in local, state or federal planning
been used to establish the theoretical area from regulations, other published documents or be
which the project could be visible. This established through community consultation
theoretical extent is based on the centre point and engagement, or as professionally assessed.
of the proposed monopole and maps this pole (refer table 2.1)
at a range of heights. The analysis uses a digital
terrain model to identify the areas from which The level of modification refers to the extent of
views to the site may be possible. change that will be experienced by receptors.
This model uses data to a 1 metre accuracy and This change can be adverse or beneficial.
does not include the filtering effect of trees and Factors that could be considered in assessing
buildings. magnitude are: the proportion of the view
affected; extent of the area over which the
change occurs; the size and scale of the change;
the level of contrast and compatibility.
IRIS Visual Planning + Design Page 3
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalLog in to download the original file
Large file: the download may take up to a minute.
Searchable page text hides email addresses. Original files are unchanged and may show email addresses.