F - Code Response Tables

Property
Projects
Australia

Sloping Sites
O16
On sloping sites, buildings and structures are

designed to maximise the use of the natural
topography and minimise the need for cut and fill.

S16.1

Buildings and structures on sloping sites:

a.

Have a maximum distance of 3.0m between the
ground and the lowest part of the floor of the
building or the building incorporates undercroft
skirting or screening) to the full height of any
undercroft area higher than 3.0m above ground level
at the perimeter of the building;

are of split level design that step down the slope or
have suspended floor construction;

limit the amount of cut or fill to less than 2.0m in
depth relative to natural ground level; and

do not result in the spread of fill beyond the footprint
of the building and

Table 14.25 — For Multiple Housing Type 3 — Retirement and Special Needs

Complies (S16.1)

The site slopes for the south western corner
(41.2m AHD) towards the north eastern corner
(37.8m AHD) with an average slope of 8.8%.

The proposed development does not result in an
undercroft area.

The proposed development provides a split level
design and roof form which follows the natural
slope of the site from the rear / western
boundary towards the front / eastern boundary.

Refer to the Engineering Code Assessment
prepared by Barlow Shelly Consulting Engineers
at Appendix G for details on cut, fill and retaining.

Not Applicable — The proposed development does not involve Multiple Housing Type 3 - Retirement and Special Needs

Table 14-26 — For Multiple Housing Type 4 — Conventional

Not Applicable — The proposed development does not involve Multiple Housing Typ4 — Conventional.

Toowoomba
PO Box 3686, Toowoomba Qld 4350
Phone: 07 4632 0516

Email: [email protected]

Brisbane
PO Box 1264, New Farm Old 4005
Phone: 07 3254 1566

Propertyprojectsaustralia.com.au