Negotiated Decision Notice MCU20 0071 · MCU20/0071

      f.    The property access must be located a minimum of 1m clear of existing power poles,
            streetlights or other signage. The developer is responsible for any necessary relocation
            of existing services to provide this clearance and must contact the relevant service
            authorities and comply with their requirements in relation to these works.
      Stormwater Drainage
85.   Stormwater drainage works must be constructed in accordance with the approved plans and
      in compliance with the relevant standards and best engineering practices
86.   Appropriate scour protection must be provided at the outlet of all stormwater pipes including
      temporary outlets.
87.   Works associated with this permit must not adversely impact on the existing drainage
      conditions on other properties (eg by blocking or interfering with natural overland flows).
88.   Construction of all internal stormwater drainage works must comply with the relevant
      section/s of Australian Standard AS/NZS 3500.3.
      Erosion & Sediment Control
89.   All necessary erosion and sediment control measures must be provided and established prior
      to the demolition works being carried out on the site.
90.   All reasonable measure must be provided and established prior to commencement of
      earthworks to prevent entrainment and export of sediments into the existing downstream
      stormwater system.
      Where required construction hold point/s with a council delegate and supervising RPEQ must
      be discussed at the prestart meeting and established prior to commencement of earthworks
      for the development. The hold point must be held as soon as reasonably practical and prior
      to the first rain event forecast following initial tree clearing or removal of soil stabilising
      material. At the hold point/s inspection, all required sediment basins, drains and/or bunds to
      divert waters away from disturbed soil or soils about to become exposed through cut to fill
      activities must be installed.
91.   Prescribed Water Contaminants (as defined in Schedule 9 of Environmental Protection
      Regulation 2008) must not be released from the site or to waters within the site, or be likely
      to be released should rainfall occur, unless all reasonable and practicable measures are
      taken to prevent or minimise the release and concentration of contamination.
92.   Sediment and erosion control measures must be in place prior to works commencing. If such
      measures are not in place or are not satisfactory, “on the spot” fines may be issued. Such
      fines can be issued if sediments from the site are found to enter or have the potential to enter
      Council’s stormwater system, natural waterways, any downstream stormwater filtration
      system or adversely impacting on other properties. The sediment and erosion control design
      and measures have NOT been approved, it is the site's Supervising Engineer who is
      responsible for ensuring that the sediment and erosion control measures have:
      a.    Been duly designed by an RPEQ or CPESC and constructed in accordance with "best
            practise" methods,
      b.    Been revised by an RPEQ or CPESC to address the issues raised by changes in the
            projected construction schedule and/or methods,
      c.    Been revised to address predicted rainfall events, and
      d.    Achieve the desired environmental outcomes.
      Council may request further controls to be installed should the implemented measures be
      found inefficient.
93.   The erosion and sediment control measures must be designed, installed and maintained in
      accordance with the supervising engineer instructions and the current best practice
      standards * (Refer to Advisory Note).




                                                                                      Page 13 of 21