Skip to the record
Search everything, all in one place.

Council archive · source document

Minor Change Report RAL24 0003 01 (As Published) · RAL24/0003.01

of 7

Text shows just the words. Original shows the document exactly as it was published.

               2.     BACKGROUND
               A development approval for a Reconfiguring a Lot – 1 into 2 lots was approved on 23 July 2024,
               this approval required amended plans be provided in accordance with condition 3.
               An amended plan (Plan of Reconfiguration) was provided and subsequently endorsed by Council
               on 16 September 2024.
               3.     ASSESSMENT
               3.1. Instruments for Statutory Assessment
               Under the Planning Act 2016 the application must be assessed against each of the following
               statutory planning instruments to the extent they are relevant to the development:
               •      State Planning Policy;
               •      South East Queensland Regional Plan;
               •      Planning Regulation 2017; and
               •      Noosa Plan 2020 (25 September 2020).
               3.2. Statutory Process
               The applicant has requested to make a minor change to a development approval under s78 of the
               Planning Act 2016. An application for a minor change to a development approval can only be made
               in circumstances where a change would constitute a ‘minor change’.
               The proposed change to the development approval requested by the applicant is determined to
               constitute a minor change on the grounds that:
               •      the development would not result in substantially different development;
               •      the change does not include prohibited development;
               •      the change would not require the application to be referred to an additional referral agency
                      or cause a referral agency to have regard to new matters prescribed by regulation;
               •      where the original application was code assessable, the change would not cause the
                      application to become impact assessable.
               3.3. Statutory Instruments – Planning Scheme
               The original application was lodged and assessed under the current Noosa Plan 2020.
               The following codes from Noosa Plan 2020 are applicable to this development:
               •    Rural Residential Zone Code;
               •    Reconfiguring a Lot Code;
               •    Works Codes;
               •    Biodiversity, Waterways & Wetlands Code
               •    Bushfire Hazard Code
               •    Landslide Hazard Name Overlay Code
               Existing Condition 8
               Fencing to Protected Land
               8.     A permanent fence must be constructed along the entire length of the interface of proposed
                      Lot 362 with the Vegetation Protection Covenant area. The fence must be constructed in
                      accordance with an Operational Works approval and must be to the following specifications:
                      a.      Min 1.5 metres high
                      b.      Dog proof
                      c.      Constructed of fireproof materials


                                                                                                     Page 3 of 7

Document Set ID: 24009176
Version: 3, Version Date: 12/08/2025

Used in these records

About this file

File size
4.6 MB (large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

Minor Change Report RAL24 0003 01 (As Published).pdf · 4.6 MB (large file)

The download may take up to a minute.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.