Skip to the record
Accept no substitutions.

Council archive · source document

001593F0.001

of 39

Check the original when the exact wording matters.

Plans and drawings: the text below has words only, no drawings.

Log in to see the plans as drawn

Text sections not matched to the original PDF pages. See original document to check page numbers.

r       ?

       Recommendations given in this report are based on the information supplied by the client regarding
       the proposed building construction in conjunction with the findings of the investigation. Any change
       in construction type, building location or omission in the client supplied information, may require
       additional testing and/or make the recommendations invalid.
       The recommendations herein identify a target soil stratum into which the footings are to be founded.
       The target stratum has been located by the depth in mm of the target stratum’s upper horizon boundary
       below the existing ground surface level at the time of the site investigation. Any cutting or filling
       works and any surface erosion or deposits subsequent to the site investigation, will alter the measured
       location of the stratum relative to the surface. Where required, the author should be notified in such
       cases to confirm the location of the target stratum.
       The description of the soil given in the Soil Profile section of this report is intended as a brief
       overview of the soil's primary constituents. For a detailed classification of the soil, the reader should
       refer to the Soil Profile Reports and/or Borehole Reports attached to this report.
       Every reasonable effort has been made to locate the test sites so that the borehole profiles are
       representative of the soil conditions within the area investigated. The client should be made aware
       however, that exploration is limited by time available and economic restraints.   In some cases soil
       conditions can change dramatically over short distances, therefore, even careful exploration programs
       may not locate al] the variations.
       If soil conditions different from those shown in this report are encountered or are inferred from other
       sources, then the author must be notified immediately.
       This report may not be reproduced except in full. The information and drawings provided with this
       report shall only be used and will only be applicable for the development shown on the client supplied
       information provided for this site.
       Any dimensions, contours, slope directions and magnitudes shown on the Test Locality Plan shall not
       be used for any building construction or costing calculations.   The purpose of the plan is to show
       approximate location of field tests only.
       Any changes made to these recommendations by persons unauthorised by the author will legally be
       interpreted as that person assuming the responsibility for the long-term performance of the footing
       system.
       The recommendations contained in this report have not taken into consideration the long term effects
       of any previous, current or potential subsurface work by mining companies or potential slope
       instability problems. At the time of writing this report neither our client (nor his agent) nor the local
       authority had made the author aware that these problems may be affecting this allotment. If a mining
       subsidence or slope stability assessment is required for this allotment, the recommendations of a
       suitably qualified geotechnical engineer should be sought.

                                                         4

Used in these records

About this file

File size
2.9 MB (large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

001593F0.001.pdf · 2.9 MB (large file)

The download may take up to a minute.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.