MCU16/0012 Attach B Engineering report & SMP

    4. Slide the Top Section along the T Sections until it sits in the center of the pit.




    5. Check unit to ensure a good fit with pit, if the unit does not make a good fit, and that any gaps are less
       than 15mm. If the gaps are larger than 15mm the plastic will need to be replaced by a larger section.

    6. On each strut drill a 5mm hole through the Top Section and the T Struts, and secure the Top Section to
       the struts using a 73AS6-8 pop rivet. NOTE: if the EnviroPod incorporates a cage, step 6 can be
       completed during stage 2 of “Cage Installation”.




    7. Check plastic to ensure that it is bent upwards on all sides, adjusting plastic if required, fill small gaps
       with silicon sealant if required.




©2013 Stormwater360 | EnviroPod Installation Manual                                                                   7