Council archive · source document
Minor Change Report 172006.2794.01
APPLICATION FOR A MINOR CHANGE TO A DEVELOPMENT APPROVAL Author Development Planner, Lisa Pienaar Development Assessment APPLICATION DETAILS Application No. 172006.2794.01 Development Approval Preliminary Building Works for a dwelling – sand dune problem area Applicant Keencrown Pty Ltd Tte Request Received On 30 June 2020 PROPERTY DETAILS Property Address 50 Tingira Cres Sunrise Beach Qld 4567 RP Description Lot 38 RP 126838 Land Area 650.37m2 Existing Use of Land Dwelling STATUTORY DETAILS SEQRP Designation Urban footprint Locality Eastern Beaches Zone Detached Housing Overlays Biodiversity overlay Natural Hazard overlay – Slide Hazard Natural Resources overlay – Coastal Protection, Coastal building line Assessment Type Minor Change to Development Approval PROPOSAL The applicant seeks approval to change to an existing development approval for Preliminary Building Works (dwelling in sand dune problem area) to change the external façade of the house with cladding to the front and sides of the building. Changes also include external screens which are to be fitted to the western façade which will encroach 0.58m further into the front setback than the current built form does. A new gate and treatment to the front fence is also proposed. A store room shown on the approved plans at the north western corner built to boundary no longer exists, appearing to be previously integrated into a garage, as shown on the proposal plans. External stairs shown on the approval plans at the northern elevation are not identified on the proposal plans. The applicant proposes to use a mix of Travertine stone cladding, metal or composite cladding, render finishes, and timber look aluminium screens. The existing block front fence will also be cladded with travertine stone. Refer to Figures 1 & 2 below. Figure 1 – Subject site Figure 2 – proposed changes to existing dwelling background A development approval for Preliminary Building Works for the dwelling was decided on 4 June 2007 (2006/2794) – Dwelling in Sand Dune Problem area. The approved dwelling included boundary relaxations to the front and rear of the property. Refer to Figure 3 – existing approval. Figure 3 – existing approval assessment Instruments for Statutory Assessment Under the Planning Act 2016 the application must be assessed against each of the following statutory planning instruments to the extent they are relevant to the development: State Planning Policy; South East Queensland Regional Plan; Planning Regulation 2017; The Noosa Plan. The following codes from the Noosa Plan are applicable to this development: Building Works Code Statutory Process The applicant has requested to make a minor change to a development approval under s78 of the Planning Act 2016. An application for a minor change to a development approval can only be made in circumstances where a change would constitute a ‘minor change’. The proposed change to the development approval requested by the applicant is determined to constitute a minor change on the grounds that: the development would not result in substantially different development as the proposal relates to minor building works to an existing approval; the change does not include prohibited development; the change would not require the application to be referred to an additional referral agency or cause a referral agency to have regard to new matters prescribed by regulation; where the original application was code assessable, the change would not cause the application to become impact assessable. Statutory Instruments – Planning Scheme Noosa Plan seeks that detached dwellings are attractive and consistent with the developed character, form and scale of surrounding development. It also seeks that buildings and structures use materials and finishes that complement the beachside character of the Eastern Beaches locality. Tingira Crescent and surrounds has a mix of built form with pitched and skillion style roof forms. There are also some examples flat roofed buildings. Condition 1 1. Development undertaken in accordance with this approval must generally comply with the approved plans of development. The approved plans are titled and numbered site plan, WD01(D); Floor Plans, WD- 03(D); Elevations, WD-05(D) prepared by Wiltshire Stevens Architecture and dated October 2006 and as may be amended by these conditions and annotations on the plans. Applicant’s Request The applicant seeks to change to existing Condition 1 to include a new set of plans reflecting the change to the façade of the building. Assessment of Request Setbacks The proposal does not comply with the Acceptable Solution S1.1 of the Detached House code with regard to the front and side setbacks. The approved dwelling does not currently comply with these requirements either. The below table – Figure 5 – setback table shows how the setbacks are varying. Figure 5 – setback table Currently the dwelling is setback 3.7 metres to the front boundary. The proposed cladding and screening on the front of the building will encroach within the front setback a further 0.58 metres, although the building itself does not. The yellow measurement in Figure 6 shows where the current setback is to the front boundary. Figure 6 – proposed and existing setback The typical front setback pattern of the eastern side of Tingira Cres is 4 metres and less where there are pools, entry porch etc.). These lesser setbacks are generally found where sites fall away from the road, in order to gain adequate access to the site and to utilise the land effectively. It is noted that on the high side and northern end of Tingira, dwellings are generally setback 6 metres. The applicant is also seeking relaxations to each of the side boundaries. It is noted that currently the side setbacks do not comply with S1.1 of the Detached housing code where the dwelling is between 4.5- 8 metres in height. A further encroachment of 0.31 metres to the southern boundary is created through the use of cladding, resulting in a setback of 1.74 metres in lieu of 2 metres. The adjoining land is public land commonly utilised for hang gliders. There are no amenity impacts relating to this change. With regard to the northern boundary setbacks, the applicant is seeking additional encroachments to allow for new cladding and façade resulting in a further encroachment of 0.44-0.81 metres. The proposed setback is proposed to range from 1.24-1.805 metres to the proposed screening or 1.75-2.11 metres to the dwelling wall in lieu of the required 1.5 and 2 metre setback requirements. It is noted that the store area was originally located on the boundary. This has been relocated into the existing garage. Refer to Figure 7 – northern setback. Figure 7 – northern setback The proposed changes result in the use of a mix of materials and material suited to the coastal environment and improve the aesthetics of the existing building. There are no issues associated with the proposed changes. No removal of vegetation is indicated by the applicant for removal. Planting is proposed in the front setback as shown on the plans. It is noted that there are no conditions on the current approval that relate to the retention or planting of native vegetation alongside boundaries. Therefore it is recommended to include a condition that requires the site to include a total of 20% soft landscaping across the entire site and plantings that grow greater than 2 metres in the front setback in order to soften the building. Coastal Protection overlay The Overall Outcomes of the Natural Resources Overlay seeks that development within the Coastal Protection Area does not adversely impact upon natural coastal processes and is designed to protect the visual amenity enjoyed by users and others. To achieve the Outcome, the relevant Probable Solutions requires a minimum 6m building setback and 5m of landscaping along the seaward boundary to provide a buffer to protect the dunal system and character of the beachfront. It is noted that the site and the plans indicate sufficient vegetation at the seaward side of the dwelling. It is noted that a rear deck in the original application was approved prior to Noosa Plan is sited between 2-4 metres from the seaward boundary. This is contrary to Noosa Plan which requires a 6 metre setback from the seaward boundary (where there is no coastal building line). However, the proposed changes do affect the seaward part of the building. noosa plan 2020 The subject site is zoned as Low Density Residential under the Noosa Plan 2020. The provisions for this zone under Noosa Plan 2020 are similar to that under Noosa Plan 2006. No change to the assessment or recommendation would change as a result of the new provisions of Noosa Plan 2020. cONSULTATION Referral Agencies Not applicable Other Referrals Not applicable conclusion & reasons for decision The proposal proposes cosmetic changes to the façade on an existing and approved dwelling and does not result in additional building works towards the seaward boundary. The proposed development generally complies with the requirements of the planning scheme and does not raise any significant issues that cannot be addressed by reasonable and relevant conditions. The application is therefore recommended for approval. The report is provided in accordance with Section 63(5) of the Planning Act 2016. RECOMMENDATION With regard to Application No. 172006.2794.01, to make a minor change to an existing approval for Building Works for a dwelling situated at 50 Tingira Cres Sunrise described as Lot 38 RP 126838, Council on 28 August 2020 decided to: A. Approve the change. B. Amend condition 1 to read as follows: 1. Development undertaken in accordance with this approval must generally comply with the approved plans of development. The approved plans are titled and numbered site plan, DA-01.01 Rev B); Floor Plans, DA-02.01 Rev B; Elevations, DA-03.01 Rev B, Render of Proposed amendment DA-03.02 Rev B and Material schedule DA-05.01 Rev B prepared by In+Situ Design Office and dated 17/08/2020 and as may be amended by these conditions. C. Include the following additional conditions 10 & 11: 10. Changes to the front boundary fence must not result in a substantial change to the height of the existing fence. 11. The site is to provide a minimum of 20% soft landscaping, which includes native vegetation to be provided in accordance with Planning Scheme Policy PSP 3 – Landscaping Plants and Guidelines. Planting of species that grow higher than 2 metres is required between the dwelling and the front boundary. [word/footer1.xml] Page 8 of 9 [word/header1.xml] 3 [Attachment: image1.png (image text)] SPLOT, te | sinereees8, he [Attachment: image5.png (image text)] NALIN VV EY DF, ¢ 2 —— = = » 4 2 { j 5 { is aF) 4 = a) ( _ Ler} LAP (Ean i Sse” | | eee. CA ouss ee ¢ Qageenemee [Attachment: image6.png (image text)] af exstmcoeck "| exisrac oecx| | —egegan xAtea70 10090 en eee 9228 See TINGIRA CRESCENT 15 39 3070 +i is i ioe oO PROPOSED / SITE GROUND LEVEL FLOOR PLAN ra povsesraaes 12009 a ul ROOF LEGEND Wi EG...150 HALE ROUND STANLESS . Steet ues ~ If o».. sco Ga Staness sree. ~ HP Sounbines ~ i % 28g i ee WALL LEGEND ee cists RC ee 9ORCONC 8 ‘TOENGINEER — ow Tina INTERNAL UNNINGS 10MM PLASTERBOAR WATERPROOF PLAST TOWET AREAS. ong ee 787080 rn ess 0 zoe t PROPOSED kel APPROVET Te PROVED ~ |} \ fan Yt a “es TINGIRA CRE [Attachment: image7.png (image text)] im! Cis ih ee Pa = STREET ELEVATION __Twoenraceo G shes (O-SOUTHELEVATION OCEAN ELEVATION [Attachment: image8.png (image text)] Built Form Detail Approved Plans - Appendix A Proposed Plans - Appendix B Front Boundary Setback Boundary to roof line (west) 3,157mm 370mm Front Boundary Setback Boundary to front wall (west) 3,757mm 3,170mm. ‘Side Boundary Setback Boundary to side wall (south) 2,050mm 740mm, ‘Side Boundary Setback Boundary to side wall (north) 1,284mm ~ 2,624mm. 1,240mm — 805mm [Attachment: image9.png (image text)] Scr PROPOSED TERED HARD 10 (BELOW) m 349° 20° TORE 29"
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalUsed in these records
Minor Change Report 172006.2794.01Related documentApplication case desk ↗
About this file
- File size
- 2.4 MB (large file)
- File type
- DOCX
No other editions are linked here.
Original file
Log in to download the original file
The download may take up to a minute.