2017-08-14 General Committee Meeting Notes

RECOMMENDATIONS ONLY – NOT THE FINAL DECISION OF COUNCIL
GENERAL COMMITTEE MEETING                                                         14 AUGUST 2018


    53.   Works associated with this permit must not adversely impact on the existing drainage
          conditions on other properties (e.g. by blocking or interfering with natural overland
          flows).
    54.   Construction of all internal stormwater drainage works must comply with the relevant
          section/s of Australian Standard AS/NZS 3500.3.
          Environment
    55.   Prescribed Water Contaminants (as defined in the Environmental Protection Act 1994)
          must not be released from the site or to waters within the site, or be likely to be released
          should rainfall occur, unless all reasonable and practicable measures are taken to
          prevent or minimise the release and concentration of contamination.
    56.   Erosion and sediment control measures must be installed and maintained to minimise
          erosion on the site and to minimise the export of sediment and associated pollutants
          from the site. The erosion and sediment control measures must be designed, installed
          and maintained in accordance with current best practice standards (refer to advisory
          notes).
    57.   Prior to the commencement of the use, all site surfaces must be effectively stabilised
          using methods which have achieved effective short-term stabilisation and which will
          continue to achieve effective stabilisation in the medium to long-term (refer to advisory
          notes). For the purpose of this condition, an effectively stabilised surface is defined as
          one that does not, or is not likely to result in visible evidence of soil loss caused by
          sheet, rill or gully erosion or lead to sedimentation, or lead to water contamination.
          Damage to Services and Assets
    58.   Any damage caused to existing services and assets as a result of the development
          works must be repaired at no cost to the asset owner at the following times:
          a.    where the damage would cause a hazard to pedestrian or vehicle safety,
                immediately; or
          b.    where otherwise, upon completion of the works associated with the development.
          Any repair work which proposes to alter the alignment or level of existing services and
          assets must first be referred to the relevant service authority for approval.
    FOLLOWING CONSTRUCTION
          Certification
    59.   Upon completion of the work a certificate must be issued by an RPEQ certifying that
          the works have been constructed in accordance with the Operational Works permit.
    60.   A final inspection and approval of the new works and completed reinstatement works
          by Council’s Inspector is required. Please contact Council on 5329 6245 to arrange for
          the inspection.
                                                                                        Carried.




                                                                                       Page 8 of 25