Appendix 10. Draft By-Laws [As Published] · 132007.2399

                      by the Body Corporate. This requirement will not include trellises or other shading
                      devices such as open pergolas or structures which are ornamental or used for
                      horticultural purposes to a maximum height of 2.4 metres above Ground Level
                      which are integrated into the design of the Building.

           (c)        The minimum Rear Boundary Set Back for any Building or improvements is 6
                      metres unless determined otherwise by the Body Corporate.

           (d)        Zero Lot Line Lot or Zero Lot Line Dwelling may not be erected.

           (e)        Set Back requirements imposed by law from time to time may increase (but may
                      not decrease) the Set Back requirements of these by-laws.

23.8       The minimum number of Covered Parking Spaces to be provided in connection with a Class 1a
           Building is two for motor vehicles plus, as required, one for a motorised golf cart. The
           driveway to the Covered Parking Space is to fall from the Front Boundary to Common
           Property.

23.9       Structures used to store any equipment on any Lot must be constructed of the same materials
           as a Class 1a Building on the Lot and must be of a colour consistent with that of the class 1a
           Building on the Lot and must be designed in such a way that the equipment cannot be seen
           from any thoroughfare or the Golf Course.

           Class 10 buildings with an opening visible from Common Property must have a door or shutter
           on the opening to prevent items stored in the structure from being viewed from any Common
           Property.

23.10      Privacy screens and tennis courts are not permitted to form part of the Works.

23.11      Exterior cladding will consist predominantly of rendered masonry up to first Storey level (with
           a finished decorative coat up to 2 millimetres aggregate in size) consistent with other class 1a
           Buildings at Noosa Springs. Exterior cladding to upper walls shall be rendered to match
           exterior Storey walls. Complimentary use of glazing, timber and other architectural accent
           features is permitted. Unrendered brick, blockwork, fibre cement sheeting or timber cladding,
           stonefacing, cover stripped paneling or metal, plastic or polycarbonate sheeting is not
           permitted.

           Exterior wall cladding will be within the colour range of pastel to muted earth tones
           complimentary to the approved roofing colours and compatible with other class 1a Buildings at
           Noosa Springs.

           Fascia boards, trim, exposed metalwork and must be colour co-ordinated with the Buildings
           and Works on the Lot. Unpainted metalwork is not permitted except for some natural copper
           accent features.

           Roofing must consist predominantly of clay tiles and cappings similar to that at Noosa Springs.
           Highly glazed/vitreous roof tiles are not permitted. Coated metal materials will only be
           permitted on "flat" roofs.

           Fences, storage facilities and retaining walls shall be colour coordinated with the Building and
           Works on the Lot. Adjoining lot fences to the Front Boundary and Rear Boundary in the same
           plane shall be of the same colour determined by the Body Corporate.

           Mirror finished surfaces is not permitted. In the case of glass, applied films or tints which give
           a mirrored finish and can be seen from outside the Lot is not permitted.



Legal\105410442.1                                                                                         13.