Development Application Part 1 of 2 - IDAS Form 1, Form 28, Checklist, vica versa doc details of attachment 13 Cooran Court Noosa Heads · OPW10/2100

DOCK

INSTRUCTION MANUAL

 
 
  
  
 
 
 
  
 
 
 
 
 
  
 
 
 

>» The assembly of a boat dock is very similar to the assem-
bly of a PWC dock. You will notice that the center 3 rows are
basically the same setup as the PWC V-Berth.

> Your Boat V-Berth will come in groups of 6 floats. The
stern section will be fully assembled.

» Beginning with the stern section, follow the same instruc-
tions as with the PWC dock moving forward until the center
section is complete.

> To fill out the outside rows, you will need to disassemble
the extra 6 packs that come on the pallets.

> Start on one side and setup the floats to attach to the sides
of the floats from the center channel. Pay attention and make
sure that the 1 and 4 tabs are pointing towards the shore.

» The Double floats will be installed in a staggered format so that the seams of the floats overlap the float next to it. Consult the
diagram of your dock for a layout.

Placing Lugs, Attachment options, and Winch
>» You are now ready to put the lugs around your dock. Lugs are required along the stern of the dock. The bow must have also

have lugs. The bow lugs will typically be the 1-4 combination and the nut can be installed upside down on the #1 tab to act
as a filler.

» When installing the winch—use the spacers provided and use the sliding nuts in the normal position to ensure that the winch
assembly is secured in place

> For the sides of the dock, beginning at the stern, put lug connectors on the tabs of where the double floats meet. This will be
approximately every other one.

» Make sure all attachment options and accessories use a white exterior lug connector.