Council archive · source document
07/0786 - MCU - Detached House [As Published] · 132007.786
Detached House Code bese UE Saae aN Lae) Setbacks O7 Buildings and other Structures are appropriately designed and sited to— a) provide amenity for users of the premises as well as preserve the visual and acoustic privacy of adjoining and nearby land uses; | b) preserve any existing vegetation that will buffer the proposed building from adjoining uses; C) allow for landscaping to be provided between buildings; and d} maintain the visual continuity and pattern of buildings and landscape elements within the street. SBR alternative Provision to QDC Parts 11 and 12, P1, P2 and P7 ACCEPTABLE SOLUTIONS $1.1 The minimum setback of the Detached house or dwelling unit and associated buildings and structures from boundaries is not less than the minimum specified in Schedule 1; or $1.2 Where there is a conflict between boundary setbacks in Schedule 1, the greater of the setbacks prevails; AND $1.3 If there are no applicable setbacks shown in Schedule 1, the siting provisions of Part 11 or 12 of the Queensland Development Code apply. SBR alternative provision to QDC Parts 11 and 12, A1, A2 and A7 COMPLIANCE The indicated boundary setbacks for the proposed dwelling are as follows: Front Setback: Om Side NW: 1.5m Side SE: 1.5m Rear: 9m Performance Solution Required Flooding and drainage 02 Buildings and other works are designed and sited to— a) provide flood free access to premises and flood free habitable areas; b) allow only minor, short term and infrequent flooding of non-habitable areas; c) ensure drainage does not adversely impact upon other premises; and d) ensure filling or excavation does not adversely impact upon other premises by— i. causing ponding of water on the site or nearby land; and ii. increasing flooding, which adversely affects the safety or use of any land upstream and downstream; and iii, adversely affecting the $2.1 For new buildings or structures or additions of more than 50m2 to an existing building or structure —floor levels of habitable rooms are— a) for areas where minimum floor levels are available—not less than the specified level; b) for areas where flood modelling is available—a minimum of 500mm above the modelled flood level; and c) for areas where flood modelling is not available, a minimum of 500mm above the highest known flood level;18 or $2.2 For additions of not more than 50m2 to an existing building or structure —floor levels of habitable rooms are not less than the level of other habitable rooms in the building or Structure; AND $2.3 Filling, other than accessways, does not extend more than 1m beyond the footprint of any building or structure, measured from outer walls of the building or structure. Advisory note Council encourages building methods that There are no flooding issues pertaining to the site. The proposal incorporates a stepped design which minimises the need for cut or fill, Fil will not extend more than 1m from the main building line.
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalUsed in these records
07/0786 - MCU - Detached House [As Published]Related documentApplication case desk ↗
About this file
- File size
- 7.8 MB (large file)
- File type
No other editions are linked here.
Original file
Log in to download the original file
The download may take up to a minute.