Skip to the record
The only place to find full transcripts.

Council archive · source document

0015584F.001

of 69

Text shows just the words. Original shows the document exactly as it was published.

Check the original when the exact wording matters.

Text sections not matched to the original PDF pages. See original document to check page numbers.

Project No. 306-2474
November, 2006                                                                          Page 9
   6.6   Retaining Walls
      6.6.1   General
      It is understood that retaining walls would be required to retain the sand material in order
      to construct the basement ground floor platform. We understand the expected maximum
     retained height will be in the order of 4.5 metres. Retention systems should be designed
     in accordance with AS 4678-2002 'Earth Retaining Structures’.
     6.6.2    Pressure Distribution
     The lateral earth pressure from the active pressure wedge, where:-
              P        =       0.5 KH?
              P        =       active force resultant acting at a height of H/3
                               from the base (kKN/m run of wall)                                 @
             V4       =        density of sand, kN/m?
             Hi       =        height of wall (m)
             Ks       =        active pressure coefficient
    Until the base of the wall is prevented from inward movement by the strutting action of
    the basement floor, the resistance of movement is provided by the friction of the soil
    beneath the base slab, and by the passive resistance of the soil against the vertical face
    of the toe of the wall. The intensity of passive resistance can be calculated from:-
             P        =       0.5 Kp ¥ H2?
             Kp       =       Passive pressure coefficient
             Hz      =        front face of wall contributing to passive resistance (m)           @
    The lateral pressure distributions shown in Figure 2 includes hydrostatic pressure and
    show typical surcharge loadings pressure distribution.      Due to possible long term
    problems with blocking of gravel filters and drains and short term storm conditions that
    could flood the fill behind retaining walls, it is recommended that all retaining walls be
   designed for some water pressure distribution. A suggested water pressure distribution
   for retaining walls on this site would be one third height water pressure.
   For the calculation of sliding resistance, base friction for walls without a key may be taken
   as tan (2/3 ©). If the wall has a shallow base key the shearing resistance may be based
   on tan @. Refer to Table 4 for the friction angle of sand.

                    a
                                                       YF  SOIL SURVEYS ENGINEERING

Used in these records

About this file

File size
4.1 MB (large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

0015584F.001.pdf · 4.1 MB (large file)

The download may take up to a minute.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.