2010 SCC Decision Notice · REC14/0015

2009/8343

 

development approval for any associated Operational Works. The cash bond or trading bank
guarantee will be returned on performance of the conditions of approval less any costs incurred
by Council in respect of enforcing performance of this permit.

Vehicle Access

12.

13.
14.

15.

16.

The common access driveway to proposed Lots 49, 50 and 51 from Starboard Avenue shall be
generally in accordance with Job 09595 Drawings P2 and P3 issue T1 dated September 2008
by TOD Consulting and subject to the following additional requirements:

12.1. Designed and constructed in accordance with Noosa Planning Scheme Policy 5 —
Engineering Design Standards — Roads, Drainage and Earthworks and Council
standards, :

12.2. The first 6m of the driveway measured from the kerb line in Starboard Avenue shall be
* 5m wide,

12.3. The driveway at the T-intersection of the access handle shall be of sufficient width to
allow for two vehicles (B99 vehicles as described in AS/NZS 2890.1:2004) to pass each
other at the intersection,

“42.4. The: driveway near Lots 50 and 51 shall be of sufficient width to allow a vehicle (B99

vehicle as described in AS/NZS 2890.1:2004) to reverse out from the lot and proceed in
forward gear in a total of two movements.

A Development Permit for Operational Works shall be required.
Allvehicles shall enter and leave Lot 49 in a forward direction.

A vehicular access driveway to serve Lot 48 shall be provided from the Eumundi Noosa Road
frontage of the site generally.in accordance with IPWEAQ Drawing No: SEQ R-050.

y

All driveways shall be designed and constructed to Council's design standards and to grades
that prevent vehicles from scraping and/or bottoming whilst also allowing pedestrians
movements along the footpath without any step or level difference. Should any driveways be
constructed to grades that do not comply with AS/NZS 2890.1-2004 and AS 2890.2-1989,
Council will require that the driveway be removed and reconstructed to levels that do comply.

Please note, a step between the driveway and the footpath shall be avoided, as it is preferred to
have the footpath continue at a constant grade to minimise the potential for pedestrians to trip
or fall. ,

To ensure pedestrian safety between vehicles exiting the site and pedestrians on the footpath,
the driveway and any associated fencing or vegetation near the driveway shall comply with the
minimum. sight line requirements as defined in AS 2890.1, section 3.2.4. The applicant shall
demonstrate compliance by illustrating these sight lines on the plans submitted for both
Operational Works approval and Building Works approval.

Vehicle Access Easement

17.

An easement for vehicular. access and services shall be created over the proposed T-Shaped
access handle on Lot 49 and to the benefit of Lots 50 and 51. The easement-shall be 8m wide

. for the leg section and 10m wide for T head (with the width being increased to accommodate

passing lanes and vehicles turning areas if necessary).

In this regard, plans submitted for Operational Works approval shall accurately show the
location ‘and dimensions of the easement. In addition to this the Applicant’s Solicitor shall give
Council's Solicitor an appropriate undertaking in writing that the Title Deed and the easement
documents will be lodged at the Land Titles Office and any additional Titles Office forms or
requisitions requiring the consent of Council will be attended to promptly.

A duly executed copy of the easement shall be submitted to Council for perusal prior to the use
commencing.

3 of 13