Skip to the record
The gold standard in government transparency.

Council archive · source document

Part 17 of 37 Appendix 15 - Groundwater Assessment MCU12/0208

of 103

Text shows just the words. Original shows the document exactly as it was published.

Check the original when the exact wording matters.

Very large file (60.3 MB): the whole original can take several minutes to open, especially on a phone. Text is quick to read.

www.ac      ss.gs                                                                                        +GILtEHI
                                                                                                     SUT1-ERI.AN)



concentrations in rainfall at various locations                    sewage effluent disposal to land, it contains a
throughout southern Queensland. Biggs                              water balance component which considers:

developed a mathematical description based on a                       effluent applied (in this case none)
Power function (y=axc)of the relationship
                                                                       precipitation
between rainfall chloride load and distance from
the sea. Whilst noting that these types of                            evapotranspiration
equations are extremely unreliable, a quadratic                       drainage (recharge)
equation? was developed to describe expected                          surface runoff
rainfall cr concentration using the inputs of mean
data from Biggs work and distance from the sea.                    Based on the MEDLI model, average runoff was
The intercept of this equation was 5.28 mg/L cr                    estimated to be approximately 0.2. The recharge

(95%confidence interval + 0.95 mg/L Cll                            estimates gained from using Cooks Method were
                                                                   also compared with the drainage (recharge)
Although the derivation of the quadratic                           estimates obtained from the MEDLI model.
mathematical description from this data set was
not the intent of the original researcher, in the                  3.5.7    Hydraulic characteristics
absence of any other data it is reasonable to use                  The aim of assigning aquifer parameters to the
this information to inform the estimate of the                     model is to ensure the simplest representation of
expected rainfall Chloride concentration.                          the actual hydrological regime. Whilst permeability
                                                                   was measured on site,     specific yield and porosity
The final source of the rainfall Chloride
                                                                   in the initial model set up were based on a range
concentration estimate was derived from
                                                                   derived from various texts. These are presented in
laboratory analysis of water quality from a                        Table 3.5.7.1.
freshwater spear pump bore in the frontal dune at

Burleigh Heads, Queensland. Again, for the                         Table 3.5.7.1 Porosity and yield ranges used for

purpose of the assessment, this sampling location                  calibration & modell
is sufficiently similar to the subject site.


The water analysis indicated the CI’ concentration
of the freshwater lens (above the salt water table)
was 7.1      mg/L cr. The only source of recharge is
rainfall and this chloride concentration suggests                  3.6     Calibration
that the rainfall concentration is some number less
                                                                   The model was calibrated under steady state
than 7.1.
                                                                   conditions to obtain an approximation of the site’s

Based on these data the boundaries for analysis                    groundwater regime.
of potential recharge may be derived, in this caseB
as between 3.01 to 6.1
                                                                   3.7     Sensitivity
                                mg/L cr.
                                                                   To further assess and quantify the inherent
The run-off component of the recharge estimate
                                                                   uncertainty in the model calibration process, a
equation was derived using the CRC for Waste                       sensitivity analysis was undertaken. The aquifer
Research/QDPI Model for Effluent Disposal by
                                                                   parameters were assessed using the WINPEST
Land Irrigation (MEDLI)software. Although the
                                                                   software to rank in order of greatest effect on
model is designed to assess the impact of                          calibrated model outcome.

?
    Y = 2*10.5 *x2   0.0171 X + 5.28 (R2= 0.5666, standard error
                     .

                                                                   3.8     Model limitations
of the estimate = 0.8) where Y = expected rainfall CI-
concentration mg L.1 and X = distance from mean high water         The groundwater model described in this report is
in kilometres.
B
                                                                   limited by the constraints of the Visual MODFLOW
    This upper value corresponds to the estimate using Briggs
                                                                   model itself (which are well known in the industry)
data for a site 6 km from the sea (5.3)plus the standard error
of 0.8 to give a maximum of 6.1 mg CI" L".                         as well as   by the quality and availability of input



18                                                                                 AGRICULTURE WATER ENVIRONMENT

Used in these records

About this file

File size
60.3 MB (very large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

Part 17 of 37 Appendix 15 - Groundwater Assessment MCU12_0208.pdf · 60.3 MB (very large file)

The download may take a few minutes. On mobile data, it is best to wait for Wi-Fi.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.