Council archive · source document
Part 17 of 37 Appendix 15 - Groundwater Assessment MCU12/0208
Very large file (60.3 MB): the whole original can take several minutes to open, especially on a phone. Text is quick to read.
www.ac ss.gs +GILEEHI
SUT1-ERJ.AN)
data. Nonetheless, G&S believes the current services trenches) during the construction phase,
model for this groundwater assessment is sound was calculated using the following equation:
in that it is accurate within the limitations of the
data and assumptions used in developing it. Q=KiA
Where:
3.9 Construction phase groundwater
impacts Q = volumetric flow rate (m3/day)
Groundwater drawdown associated with
K = hydraulic conductivity; (m/day)
excavations (i.e. installation of services and
removal of material) was estimated using
i = hydraulic gradient; (m/m)
Hooghoudt’s Equation -
a steady-state drainage
formula used to estimate head losses due to A = cross sectional area of the dewatered
horizontal and radial flow. While primarily used to
pit (m2)
estimate drain spacing, it also provides a useful
indicator of likely groundwater drawdown given 3.10 Post development groundwater
theoretical inputs such as:
impacts
inflow rates,
Following calibration and sensitivity analyses, the
hydraulic conductivities, model was altered to represent the developed site
scenario as described in Section 1.2 and depicted
depth of drain below surface, and
on the Masterplan for the Noosa on Weyba
allowable rise in water surface.
development provided in Appendix 1.
Hooghoudt’s Steady State Formula is shown
Development of the site will involve the removal of
below:
vegetation, installation of stormwater treatment
devices and the construction of buildings and
hardstand areas throughout the site. Each of
L2 8K2dh 4K,h2 these activities has the ability to impact upon the
+
q q characteristics of groundwater recharge and
evapotranspiration. To represent the likely
groundwater impacts associated with the
where:
development, groundwater recharge and
evapotranspiration were modified to reflect the
q = Inflow rate (mm/day)
likely reduction in recharge/evapotranspiration in
hardstand areas and the likely increase in
K1 = Hydraulic conductivity -
pipe to surface
(m/day) recharge in the vicinity of stormwater treatment
devices.
K2 = Hydraulic conductivity- below pipe
(m/day) 3.11 Sea level rise
The Noosa on Weyba development is located
d =
Depth of drain below surface (m)
within the Coastal Zone and Coastal Management
h = Allowable rise in water surface between District as defined by the Queensland Coastal
drains (m) Plan 2012. Parts of the site have also been
classified by the QCP as Coastal Hazard Areas
L = Estimated spacing between drains (m) that may be subject to:
erosion risk due to storm impact and long term
The seepage estimate or Darcian Flow Rate (the
trends of sediment loss and channel migration
potential inflow rate) associated with dry
excavation (bulk earthworks and excavation of
1 0838_GWA_ELH2F.DOCX I NOOSA ON WEYBA I NORTHBROOK CORPORATION PIL _
GROUNDWATER ASSESSMENT 19
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalUsed in these records
Part 17 of 37 Appendix 15 - Groundwater Assessment MCU12/0208Related documentApplication case desk ↗
About this file
- File size
- 60.3 MB (very large file)
- File type
No other editions are linked here.
Original file
Log in to download the original file
The download may take a few minutes. On mobile data, it is best to wait for Wi-Fi.