Original source · versioned page text
2505-45930 SRA_Response with conditions_MCU25-0025
Attached to the e-mail MCU25/0025 - SARA Referral agency response – with conditions.
2505-45930 SRA
Attachment 1—Referral agency conditions
(Under section 56(1)(b)(i) of the Planning Act 2016 the following conditions must be attached to any development
approval relating to this application) (Copies of the documents referenced below are found at Attachment 5)
No. Conditions Condition timing
Development Permit: Material change of use
10.9.4.2.4.1 – Material change of use near a state transport corridor—The chief executive
administering the Planning Act 2016 nominates the Director-General of the Department of Transport
and Main Roads to be the enforcement authority for the development to which this development
approval relates for the administration and enforcement of any matter relating to the following
conditions:
Stormwater management
1. Stormwater management of the development must not cause At all times
worsening to the operating performance of the state-controlled road,
such that any works on the land must not:
(i) create any new discharge points for stormwater runoff
onto the state-controlled road
(ii) concentrate or increase the velocity of flows to the state-
controlled road
(iii) interfere with and/or cause damage to the existing
stormwater drainage on the state-controlled road
(iv) surcharge any existing culvert or drain on the state-
controlled road
(v) reduce the quality of stormwater discharge onto the
state-controlled road
(vi) impede or interfere with any overland flow or hydraulic
conveyance from the state-controlled road
(vii) reduce the floodplain immunity of the state-controlled
road.
Vehicular access onto the state-controlled road
2. (a) The road access location is to be located generally in (a) At all times
accordance with the Site Pan, prepared by AM20 Design, dated
6 February 2025, reference CHA-001 Revision C, as amended in (b) and (c)
red by SARA. Prior to the
commencement of use
(b) Road access works (at the road access location) comprising a
vehicle crossing – rural property access must be provided.
(c) The road access works must be designed and constructed in
accordance with:
The Department of Transport and Main Roads Standard
Drawing 1807, Rural Property Access Type A, Revision
C, with a minimum throat width of 6m, sealed to the
property boundary with sloping headwalls & a 450mm
diameter pipe for drainage
the Department of Transport and Main Roads Road
Planning and Design Manual (RPDM) – second edition.
State Assessment and Referral Agency Page 4 of 7
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the original