170903 ADAMS + SPARKES Minor Change Application · 51993.615.03

   MINOR CHANGE TO EXISTING APPROVAL                                                                         2
   6/13 NOOSA PARADE, NOOSA HEADS
                 c) Does not ‘dramatically’ change the built form, with the development only resulting in
                    an increase to Gross Floor Area (“GFA”) by 17m2; and,
                 d) Does not remove any element of the development and does not introduce any new
                    impacts, or significantly increases the severity of known impacts, given that the
                    development only proposes one additional bedroom and does not increase the car
                    parking requirements.
       •    Does not result in prohibited development, require referral to any referral agencies or require
            public notification.

   Based on the above, the proposed changes to the original Development Permit, are consistent with the
   definition of a ‘Minor Change’. As such, it is requested that Council consider this application under Section
   78 of the Planning Act 2016.


1. Background/Proposal Overview
   Council issued a Development Permit for Multiple Dwellings (16 Units and Caretakers Residence) at 13
   Noosa Parade, Noosa Heads on 22 December 1993 (Council Ref: TPC 2557). An application to Change the
   Development Approval was approved by Council on 27 November 2008, which approved minor variations
   to the Caretakers Residence.

   The application seeks to gain approval to extend existing Unit 6 by 17.50m2 on the ground floor, to
   facilitate the construction of an additional bedroom and associated ensuite. Inclusive of the proposed
   additions, Unit 6 will contain a GFA of 66.50m2. As illustrated in Figure 1 below, the development will
   include the partial demolition of an architectural blade, as well as a section of an external wall, which is
   required to ensure that internal access to the additional bedroom is provided.




                                                                            Proposed Bedroom/Ensuite




   Figure 1 Proposed Extension (Source: DCM Building Design)


   As demonstrated in Figures 2 and 3 below, the proposed addition has been designed such that it is
   reflective of the existing architecture, with the proposed addition containing a curved roof that matches
   the radius of the existing roof form. As detailed above, the proposed additions are ground level only and
   contains a varying height from 2.3 metres to a maximum of 3.7 metres, due to the radius of the roof form.
   TIM BARRETT AND JANE EAKIN
   MARCH 2018