Decision Notice - Council Meeting Decision - MCU23 0007 & RAL23 0001 (As Published) · MCU23/0007

                            DEVELOPMENT PERMIT FOR RECONFIGURING A LOT – (RAL23/0007)
                  When Conditions Must Be Complied With
          1.      Unless otherwise stated, all works required by the conditions of this Decision Notice must be
                  completed prior to submission of the subdivision plan to Council for compliance assessment.
                  Currency Period
          2.      This development approval lapses if the requirements of the conditions have not been completed
                  and an application for plan seal is not lodged with Council by 15 October 2030, unless an
                  application to extend the currency period is approved by Council.
                  Approved Plans
          3.      Development authorised by this approval must be undertaken generally in accordance with the
                  Approved Plans listed in the table below.

                    Plan No.       Rev.    Plan/Document Name                                                 Date

                    0003           B       Subdivision Plan prepared by Push                                  14/09/2026

          4.      All lot numbering on the subdivision plan to be submitted to Council for compliance assessment
                  must remain as shown on the Approved Plans.
                  Boundary Encroachments
          5.      Certification must be submitted to Council from a Registered Cadastral Surveyor (Qld) which
                  certifies that:
                  a.      the setback/s to any new boundaries for any existing buildings remaining on the site comply
                          with the relevant provisions of the planning scheme and the Building Act 1975, unless varied
                          by this Decision Notice
                  b.      all constructed access and roadworks (including associated fill batters and retaining walls)
                          are fully contained within a dedicated reserve or registered easement
                  c.      all utility services and connections (eg. electricity, telecommunications, water, sewerage)
                          are wholly located within the lot they serve or alternatively included within an easement
                  d.      all retaining walls and structures are fully contained within the lot they retain
                  e.      any fill, including fill batters, are wholly contained within the subject site and not on adjacent
                          properties
                  Property Access and Driveways
          6.      Vehicle access to proposed Lots 1 and 2 is limited to the constructed driveway only. A clause
                  must be included in the contract of sale for the lots which requires vehicle access to be from the
                  constructed driveway only, and which prohibits the driveway from being relocated without Council
                  agreement.
                  Easements
          7.      An easement for drainage purposes must be registered in favour of proposed Lot 1 against the
                  title of all lots (nominally proposed Lot 2) which convey stormwater from proposed Lot 1 through
                  proposed Lot 2 to a Lawful Point of Discharge in Myall Street. The easement must be a minimum
                  width of 1.5 metres located centrally over the proposed drainage structures or of sufficient width
                  to wholly encompass the drainage structures. The easement must be granted prior to the
                  commencement of any works associated with this approval.
          8.      Unless otherwise agreed in writing by the relevant service provider, any public or third-party
                  infrastructure located on the subject site must be placed within an easement registered against
                  the title of the property.




                                                                                                     Page 9 of 22
Document Set ID: 25255015
Version: 5, Version Date: 22/10/2026