Decision Notice - Minor Change - 132007 738 05 [As published]

               71.    A construction management plan/strategy to ensure no damage occurs to Council services
                      shall be prepared by a suitably qualified Registered Professional Engineer and submitted to
                      Council in conjunction with any application for Operational Works.
               72.    Any damage caused to any public utility during the course of construction shall be repaired
                      to Council’s standards and at no cost to Council.
               73.    Any alteration of any public utility or other facilities necessitated by the development of the
                      land or associated construction works external to the site shall be at no cost to Council.
               74.    The transportation of all materials to and from the site shall be undertaken in a manner such
                      that no particle matter escapes onto a public road. All vehicles carrying materials either to
                      or from the site shall be covered to prevent materials including dust being windblown from
                      the vehicle.
               75.    As Constructed drawings and data shall be certified by a qualified experienced Civil Engineer
                      for design intent, and a Licensed Surveyor shall certify the cadastre and the location, level
                      and type of all services and structures. All of which shall be submitted to Council for checking
                      and for Council’s records.
                      The data must fully detail levels for all engineering works including but not limited to
                      drainage structures, finished ground levels and pavement surface levels. The data shall be
                      submitted in the Asset Design and As Constructed (ADAC) digital format. (Guidelines on
                      the use of ADAC are available at www.adac.com.au).
               76.    Approval of works shall not be granted until all As Constructed information has been supplied
                      and accepted by Council.
               Environmental Health
               77.    Refuse containers must be provided in accordance with the requirements of the
                      Environmental Protection (Interim Waste) Regulation 1996 and (Waste Management)
                      Regulation 2000, for the storage and collection of refuse.
               78.    The Operational Waste Management Plan (OWMP) dated 20 May 2008 submitted is not
                      approved and shall be amended and re-submitted to Council for approval prior to the issue
                      of a Development Permit for Operational Works. The revised OWMP shall address the
                      following:
                      a.      Additional skip bin storage areas for Bulk Recyclables for the eastern and western
                              areas of the development in addition to the refuse storage areas as indicated in the
                              Operational Waste Management Plan dated 20 May 2008 Job No. 7800/62.
                      b.      Provision for waste generated from food, mechanical, boat repair and other industries,
                              in accordance with the range of approved uses.
                      c.      A minimum separation distance of 500mm between bins to be collected by robotic arm.
                      d.      Flat or minimal grades where industrial bins are to be manually shifted by refuse
                              collectors.
                      e.      The role of the Body Corporate Manager is to be clarified. If no on-site manager is
                              proposed then the OWMP is to be revised to adequately address the day-to-day
                              management of waste issues on the site.
               79.    There shall be no awnings or building overhangs along the refuse truck travel path or
                      manoeuvring areas.
               80.    A Waste Management Plan (Construction) shall be submitted in accordance with Planning
                      Scheme Policy 11, Waste Management Plans. Waste storage areas are to provide for
                      adequate separation of all reusable, recyclable and waste materials. These shall be located
                      so that they are convenient and safe to use (refer to Noosa Council Waste Management
                      Code).
                      The Plan shall contain the following information:



                                                                                                      Page 11 of 17
Document Set ID: 22829529
Version: 4, Version Date: 29/02/2024