Original source · versioned page text
Approved Plans - RAL23 0021 & OPW23 0177
Plans and drawings: the text below has words only, no drawings.
Very large file (101 MB): may take a few minutes to open.
NOOSA COUNCIL Site Preparation and Planting Notes:
Determining the Radius of the TPZ (Tree Protection Zone)
APPROVED PLAN 1. Weed spray 500mm circumference around stake (remove weeds).
2. Install 900mm hardwood garden stake spray painted red at plant location.
3. Install 1m wide weed mat per manufacturer's specifications.
·
·
DBH (Diameter at Breast Height) - nominal trunk diameter at 1.4m above ground level
TPZ should not be less than 2m nor greater than 15m (except where crown protection is required) RAL23/0021 & OPW23/0177 4. Plant tubestock per detail below.
· TPZ = DBH X 12
·
·
TPZ of palms, other monocots, cycads and tree ferns should not be less than 1m
Variations and encroachments to the TPZ in accordance with A.S. 4970-2009
16 JAN 2024 3x Bamboo stakes, triangularly spaced
Install 'Suregro' tree guards or
equivalent product as per
manufacturer's recommendations
(if required, confirm with site
Timber Specification: 3x Tube Ø superintendent and LA, contractor to
Unseasoned hardwood, Class 1 Select Grade F17, ACQ or Tanalith E minimum H4 treatment, provide alternate pricing rate per tube)
with one coat of timber coating.
Galvanised timber Tubestock plant, refer to plant
fixing screws, typ. schedule for species
Fluorescent orange 5.5k.g Form shallow saucer shaped
barrier fencing mesh secured depression around plant base
/ tied 100mm below top of star
Measurement pickets at 300mm centres 1m² pinned weed mat, typ., install per
taken for DBH manufacturer's specifications
Yellow plastic capped
Fencing 100mm deep organic as specified,
star pickets
painted yellow ELEVATION minimum 50mm clear of plant stem
Vegetation to 1200mm
1.4m
be protected
Ground line
Crown DBH Cultivated subgrade and plant pit to 150mm
600mm 1200mm, maximum
TPZ
PLAN
NOTES:
· Protective fencing to be installed around the TPZ to the commencement of any site works
· Protective fencing identifying the TPZ, to be visibly signed within the development site. Lettering to comply with 150mm x 50 mm timber edging 50mm x 25mm x 450mm Topsoil per specifications
A.S.1319. hardwood peg
· Fence posts and supports to have a diameter greater than 20mm, located clear of roots 20mm @1200mm centres 5 gram 'Agriform' tablet as specified.
· Where tree protection fencing cannot be installed, trunk, branch and ground protection as specified by the project Turf as specified Use phosphorus free tablets for
Mulch as specified
Arborist in accordance with A.S.4970-2009 2x hot dipped galvanised
Banksias, Callistemons and Grevilleas
· Within TPZ, mulch to a depth of 50-100mm only for disturbed land triple grip screw to fix mitred
· Maintenance of TPZ includes regular monitoring of soil moisture levels and weed removal by hand and controlled by timber edging together,
Subgrade
appropriate use of herbicide typical.
· TPZs to be monitored, inspected and certified by the project Arborist
SECTION
· Removal of tree protection measures at practical completion or as indicated by the project Arborist
1 Tree and Vegetation Protection Detail N.T.S. 3 Hardwood Treated Garden Edge N.T.S.
LD3 Typical Detail LD3 Typical Detail 6 Tubestock Planting with Tree Guards and Weed Mat N.T.S.
LD3 For Drainage Channel Revegetation where required - Typical Section
NOTES:
Ensure crown of rootball level is set higher than adjacent finished ground levels to prevent excessive ponding around rootball. 3x Tube Ø
When footpath is adjacent to street tree install root barrier to footpath side of plant pit as per notes above.
1800
Tubestock plant as specified
Full and even crown, typical
2 - 50mm x 50mm x 2400mm F14 hardwood
centrally pointed non-treated stakes to be
STREET TREE PLANTING DETAIL PLAN driven vertically into ground outside of the Form shallow saucer shaped depression
50mm wide hessian tree ties rootball and shall have a finished height lower around plant base
wrapped loosely around trunk, than the tree's lower lateral limbs
then a figure 8 and secured to
stake with galvanised nails or Form shallow saucer shaped depression
50mm x 150mm H4 F14 hardwood timber staples. Position tree tie between 100mm deep organic mulch as specified,
Topsoil with mulch edge, refer detail, typical around base of plant and keep mulch 50mm minimum 50mm clear of plant stem
1/3 to 1/2 overall height of tree.
above - mulch to back from trunk base
Fix edging with 3x F14 hardwood
of kerb, typical 50mm x 25mm x 450mm stakes, with 2x Ameliorated site topsoil as specified, avoid
100mm deep organic mulch as specified.
galvanised nails to fix stakes to edging, typical compaction, typical
Rootball Mound mulch at edge of plant pit to collect
1800
Street tree, water to fall down edges of plant pit.
refer detail below
Turf as specified
150mm deep cultivated subgrade, typical
'Figure 8' hessian tree tie, typical
Hardwood stakes (2), see section set parallel Slow release fertiliser as specified. Use
KERB INVERT
to road, typical phosphorus free tablets for Banksia,
Tree pit to be excavated to nominal depth of
Callistemon and Grevillea species.
600mm. Backfill hole with 100% friable
Slow release fertilizer
ROAD
ameliorated site topsoil firming progressively.
as specified All excavated fill to be removed off site. Scarify
2x hot dipped galvanised triple grip screw to fix Subgrade
mitred timber edging together, typical all sides of plant pit, typical.
NOTES: 100mm deep uniform gravel layer. Provide
Extent of tree pit excavation to be 1800mm x 1800mm in area, minimum (subject to footpath location). Remove all excavated fill off-site. clean connection to road drainage as advised
Place tree, 1000mm from back of kerb, or between kerb and footpath as applicable. on site by civil engineer.
Garden areas to extend from back kerb to footpath, typ.
Edging to extend to footpaths where applicable with street tree centrally located within garden (allowing for services setbacks), refer to 4 Tree Planting - in Garden or Turf 1:30 7 Tubestock Planting N.T.S.
plans for path locations.
Ensure crown of rootball level is set higher than adjacent finished ground levels to prevent excessive ponding around rootball. LD3 Typical Section LD3 Typical Section
When footpath is adjacent to street tree install root barrier to footpath side of plant pit as per notes above.
1800
Full and even crown, typical
2 - 50mm x 50mm x 2400mm F14 hardwood
centrally pointed non-treated stakes (shown
perpendicular to kerb for graphic clarity only)
50mm wide hessian tree ties to be driven vertically into ground outside of the
wrapped loosely around trunk, rootball and shall have a finished height lower
then a figure 8 and secured to than the tree's lower lateral limbs Plant pit 2x width of respective pot. 2x pot Ø Shrub / groundcover / tufty
Scarify all pit walls and bottom, typ. grass plant species per plan 600mm
stake with galvanised nails or Form shallow saucer shaped depression Pot Ø typical
staples. Position tree tie between
around base of plant and keep mulch 50mm
1/3 to 1/2 overall height of tree.
from trunk base Backfill plant pit with specified 100mm deep and settled organic
topsoil, avoid compaction, typ. mulch as specified, keep minimum
100mm deep organic mulch as specified.
50mm from plant stem. Form shallow
Mound mulch at edge of plant pit to collect
dish drain to base of plant, typ. Varies,
water to fall down edges of plant pit. Garden topsoil as specified,
avoid compaction, typ. refer
Turf as specified Plans
Timber Edge Detail 1 - LD3
100mm, typ.
Slow release fertiliser as specified.
600
Tree pit to be excavated to nominal depth of Use phosphorus free tablets for
600mm. Backfill hole with 100% friable 2x rootball depth, typ.
Banksia, Callistemon and Grevillea
ameliorated site topsoil firming progressively. species.
All excavated fill to be removed off site. Scarify
Slow release fertilizer all sides of plant pit, typical. 150mm, typ. 150mm deep cultivated
as specified subgrade, typ.
150mm cultivated subgrade 100mm deep uniform gravel layer. Provide Existing subgrade, typ.
and pit walls clean connection to road drainage as advised
on site by civil engineer. Road Back of kerb or hardstand Turf Roll, typical
2 Street Tree Planting - Timber Edges 1:30 5 Potted Shrub, Groundcover Planting 8 Turfing
LD3 Typical Section Detail LD3 Typical Section Detail N.T.S. LD3 Typical Plan Detail N.T.S.
NOTES:
This plan is Copyrighted © by Bird Landscape Design (Brian Bird - AILA RLA #1736).
Landscape Operational Works Package Project: BIRD LANDSCAPE DESIGN
Any reproduction or unauthorized use without written consent from Job No: 2391 Proposed Multi-unit Development Landscape Architecture, Urban Design, Land Planning
Bird Landscape Design is strictly prohibited. 11C Church Street, Pomona, QLD 3 Vector Place, Little Mountain, QLD 4551 Australia
Do not scale from PDF plans. M: +614 7705 5222
All dimensions in millimetres unless noted otherwise.
LD4 Details E: [email protected]
23.10.23 A For Application BB BB
Sheet Title Sheet 4 of 7 Client: Zaccale Pty Ltd W: birdgolfdesign.com
DATE ISSUE DESCRIPTION DRAWN CKD
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalLog in to download the original file
The download may take a few minutes. On mobile data, it is best to wait for Wi-Fi.