Council archive · source document
Request for Further Information - 010.2008.00000176.001 [As Published] · 132008.176
-3-
1.3 Either carspace 1 or 35 in the south-western corner of the lower ground level
adjacent to the Visitors and Function Basement Retail parking,
1.4 Either carspace 1 or 14 in western aisle of the lower ground level adjacent to
the Store.
18. Indicate on the plans the turning paths for vehicles at the intersections in the
carparking levels. The area must be sufficient to allow vehicles to pass at the
intersections.
19. Indicate the available sight lines at the aisle and ramp intersections.
20. Provide indicative dimensions for the carparking aisles, ramps and carspaces.
21. Indicate on the plans the grades of the various access ramps.
22. Indicate on the plans the type and location of any proposed barriers to be utilised to
separate the retail and residential parking areas.
23. Indicate on the plans the location and extent of the existing landscaped median in
Serenity Close. Demonstrate how the proposed entry and exit paths of the various
vehicles will be affected the medians. The paths shall extend from entry to the site,
the path through the site and the exit path to head east along Serenity Close.
24. Demonstrate how service and delivery vehicles can access the loading areas at the
ground floor and lower ground floor levels. The vehicle path shall also include the
headroom available at each loading bay and along the vehicle access path.
Services
25. It is noted that the access ramps to the basement carparking areas traverse across
existing stormwater and sewer mains. Please provide additional detail on the
proposed vertical clearance distances between the proposed ramps and the various
services. The vertical clearances shall be in accordance with Council’s Planning
Scheme Policies PSP and PSP6.
Stormwater
26. Provide a preliminary stormwater disposal design for the proposed development. The
design shall be in accordance with the relevant approved Management Plans as
described in Decision Notice 23118 DA. The design shall include pits, pipes, on site
infiltration systems and collection and reuse tanks.
Sewer and Water
27. Provide amended drawings that clearly show:
27.1. accurate locations of all existing sewers, sewer manholes and rising mains.
27.2. that all buildings, structures, overhangs etc are clear of easements over
existing sewers. No structures will be permitted in sewerage easement,
28. Provide a Long Section of proposed finished surface level along line of existing
sewer. The Long section MUST include the accurate location of sewer.
29. Provide Cross Sections of finished levels and finishes across easement. The plans
must include cross section at all sewer manholes. Driveways, pathways, steps etc.
30. All landscaping/plantings within easements and around sewer shall comply with
Noosa Shire Council Guidelines for Planting and Landscaping (copy attached).
Drawings shall be prominently endorsed with this requirement to affected areas.
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalUsed in these records
Request for Further Information - 010.2008.00000176.001 [As Published]Related documentApplication case desk ↗
About this file
- File size
- 19 KB (small file)
- File type
No other editions are linked here.