Skip to the record
Noosa's #1 Council Tracker.

Original source · versioned page text

Planning Report - 10 independent living units

Attached to the e-mail Multiple Housing – Type 3 Retirement & Special Needs (10 units) - MCU17/0551.

of 30

Page text shows just the words. Original shows the document exactly as it was published.

Figure 6: Water Resources Mapping (DILGP November 2017)

6.4     State Development Assessment Provisions (SDAP)
The State Development Assessment Provisions (SDAP) set out the matters of interest to the state for
development assessment, where the chief executive administering the Planning Act 2016 (PA), being
the Director-General of DILGP, is responsible for assessing or deciding development applications. The
SDAP is not applied by local government in the assessment of development applications.
After review of the SDAP and the relevant mapping it is determined that no State Codes are
considered relevant to the proposed development.

6.5     State Planning Policies
In accordance with Section 43 of the PA, this application may be assessed against any State Planning
Policies to the extent that they are not reflected correctly in a regional plan or planning scheme
applicable to the application.
Upon perusal of the current State Planning Policies, all applicable State Planning Policies are
considered to be appropriately reflected in the SEQ Regional Plan and Noosa Plan 2006.




15 November 2017                               Planning Report                         Page 18 of 30
Log in to download the original file

Planning Report - 10 independent living units.pdf · 1.7 MB (small file)

Searchable page text hides email addresses. Original files are unchanged and may show email addresses.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.