Skip to the record
Accept no substitutions.

Council archive · source document

Town Planning Report · MCU13/0102

of 26

Text shows just the words. Original shows the document exactly as it was published.

Check the original when the exact wording matters.

 

Parkland boundary, with minor intrusions
permitted where footings do not adversely
impact on vegetation within the Conservation
Parkland to the reasonable satisfaction of the
Manager Land Use.

 

Built to Boundary Walls_and_ Side
Setbacks

All lots containing built to boundary walls
shall provide a minimum side setback of 3m
measured for the building fagade to one of
the boundaries to ensure open space is
maintained between each of the dwelling
units.

Where no built to boundary walls are
identified by the building envelope on the lot,
buildings shall be setback a minimum of
1.5m from one side boundary.

The maximum length of Built to Boundary
walls is 8.0m, built within a maximum of 15m
from the front boundary alignment.

The maximum height of a built to boundary
wall is 3.5m and is to be constructed with
materials consistent with the remainder of
the dwelling.

Built to boundary walls are permitted on lots
less than 600m2 and all lots which abut
conservation parklands.

Acceptable Solution

It is recognised that built to boundary walls
are permitted on lots less than 600m2, and is
therefore applicable to this lot.

The garage is built to boundary, whilst a 2.6m
side setback is provided to the balance of the
southern boundary and a 5.2m side setback is
provided to the northern boundary.

It is noted however that the roof of the sala
extends 1.6m into the northern side setback.
By definition the sala is permitted to encroach
up to 600mm into the side setback. It is our
view that the design as submitted achieves an
acceptable amenity outcome.

Additionally, because each of the houses are
clustered together for approval of the designs
as submitted, all purchasers of lots will be
making their purchaser decision in full
knowledge of the approved setbacks of the
adjoining lots.

The maximum length of the garage wall built
to the boundary is 6m within a maximum of
15m from the front boundary alignment. The
maximum height of the built to boundary wall
is 2.7m.

 

 

Building Height

Except for Lots 1-5, 9, 10 & 13 that shall not
exceed 1 storey, the maximum _ building
height of 2 storeys and 8 metres applies, in
accordance with the Schedule to the
Planning Scheme for Noosa Shire shall

apply.

Estate Sales Office:

Any Estate Sales Office or Display Home
must comply with the provisions of section
5.14 of the Transitional Planning Scheme for
Noosa Shire.

Community Use Facilities:

Community Use Facilities are to be located
in accordance with this Plan of Development
and are to be developed generally in
accordance with the Community Centre
proposal plans prepared by AV Jennings
Plans SKO1A (Feb 11), SKO2 (Feb 11) &
SKO3 (Feb 11).

 

Compliant
The proposed dwelling is configured over one
(1) storey and is below the 8m height limit.

 

Page 5 of 26

 

Used in these records

About this file

File size
1.3 MB (small file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

Town Planning Report.pdf · 1.3 MB (small file)

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.