Council archive · source document
Decision Notice - Change to an Existing Approval - 010.2005.00000353.003 [As Published] · 132005.353.03
2005/353
7. Security in the form of a cash bond or trading bank guarantee to the sum of $20,000 must be
submitted, to secure performance of all conditions of this approval, prior to the issue of a
Development Permit for operational works. The cash bond or trading bank guarantee will be
returned on performance of the conditions of approval less any costs incurred by Council in
respect of enforcing performance of this permit.
8. The requirements of this development approval are to be effected, prior to the use of the
premises. Council reserves the right to call upon the bond or guaranteed sum referred to in
this approval to effect compliance with conditions.
9. The proposed development shall have all kitchen, laundry and bathroom fittings that comply
with the AAA Water Conservation Rating System as defined by the AS/NZS 6400 (Water
Efficient Products – rating and Labelling 2003) and AS/NZS 3500 (National Plumbing and
Drainage Standard Part 1.2). All tap ware and shower roses shall not exceed a maximum flow
of 9L/min. Dishwashers and washing machines are excluded from this requirement.
10. The Development Permit for a material change of use of premises lapses if the use has not
happened by 31 December 2009 unless an application to extend the currency is approved by
Council.
Land Development
Vehicle Access
11. Two vehicular access driveways to serve the development shall be constructed from the
Belmore Terrace frontage of the site to a maximum width of 3 metres each and constructed in
accordance with Council’s standard drawing 9020.
12. Both driveways shall be designed to ensure compliance with Council’s standard drawing 9020
and AS 2890.1-2004. In particular the areas noted below shall be addressed and evidence
that compliance can be achieved shall be submitted to Council prior to obtaining a
Development Permit for Operational Works.
12.1. The driveways shall ramp up from the kerb alignment at a grade of 2% and extend
towards the property boundary for a minimum distance of 3 metres. The driveway shall
then begin to ramp down at a maximum grade of 5% for the remaining section of the
footpath up to the property boundary. Once at the property boundary the driveway is
permitted to steepen to grades that comply with AS2890.1-2004 and then smoothly
transition to the proposed garages.
12.2 All driveways and turning areas shall comply with Council’s minimum landscaped
setback of 2 metres to any road frontage and 0.5 metres to any side boundary.
12.3 The minimum distance between the driveway and any overhead structure shall be 2.2
metres. In this regard consideration must be given to the underside levels of the
building structure and the driveway to ensure adequate clearance.
12.4 The footpath levels shall be adjusted so as not to cause a trip hazard to pedestrians
near the property boundary where the footpath would otherwise be higher than the
ramped driveway.
13. If any driveways are constructed to grades that do not comply with AS2890.1-2004, Council
will require that the driveway be removed and reconstructed to levels that do comply.
14. All vehicles shall enter and leave the site in a forward direction.
Carparking
15. Carparking shall generally be provided within the site as shown on drawing number
0316(703)A-WD-1.02 Revision P6 dated 23/09/04 by In A Space Architecture & Design,
except as modified herein.
16. A minimum of 4 covered carpark spaces shall be provided on site.
Page 3 of 12
See the original
The page text is free to read. Viewing or downloading an original file needs an account.
Log in to see the originalUsed in these records
Decision Notice - Change to an Existing Approval - 010.2005.00000353.003 [As Published]Related documentApplication case desk ↗
About this file
- File size
- 72 KB (small file)
- File type
No other editions are linked here.