Skip to the record
Mmm.. taste the original NoosaWatch™

Council archive · source document

Attachment 5 - Arboricultural Impact Assessment · MCU22/0118

of 53

Text shows just the words. Original shows the document exactly as it was published.

                                                                           Consult Arborist

9.2 C ALCULATING T R EE P R OTECTION Z ONE AND A R EA TO BE F ENCE D
The descriptions of the TPZ and SRZ are taken from the Australian Standards, AS 4970-2009
Protection of trees on development sites. These descriptions only give the basic outline to
calculate the TPZ and SRZ, when encroachment or reduction in the size/area of the TPZ is
required to facilitate the development, these can also be calculated: see Appendix D of the
Australian Standard AS 4970-2009.

Please Note: as previously stated the entire site is considered a Tree Protection Zone, this
information is provided as an explanation only and additional measures will be put in place
accordingly.

9.2.1 TPZ

As specified in the Australian Standard, AS 4970-2009, the Tree Protection Zone (TPZ) is the
principal means of protecting trees on a development site. The TPZ is a calculation that
combines the root area and crown area which require protection and this area should be
isolated from construction disturbance so that the tree can remain in a viable condition for the
future. The TPZ incorporates the Structural Root Zone (SRZ).

The radius of the TPZ is calculated for each tree by multiplying its DBH (Diameter at Breast
Height - trunk diameter measured at 1.4m above ground) by 12.

For example, a tree with a .5 m diameter at 1.4m x 12 results in a 6m Tree Protection Zone
(TPZ).

A TPZ should not be less than 2m or greater than 15m (unless crown protection is required).

9.2.2 SRZ

The Structural Root Zone, as specified in AS 4970-2009 the surface area of protection that is
required around a tree to maintain that tree’s stability – a larger area than this is required to
maintain a tree in a viable condition for the future. It is only necessary to calculate the SRZ
when major encroachment into a TPZ is proposed.

An indicative SRZ radius can be determined from the trunk diameter, D, measured in metres
(above the root buttress) and applying the following formula:
                  0.42
RSRZ = (D x 50)          x 0.64

The SRZ for trees with a trunk diameter less than 0.15m will automatically be 1.5m.




22_06_13_AIA_Aspect_RACV Noosa Eco_V1                                                Page 19 of 53

Used in these records

About this file

File size
2.8 MB (large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

Attachment 5 - Arboricultural Impact Assessment.pdf · 2.8 MB (large file)

The download may take up to a minute.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.