Skip to the record
For the highest quality transcripts.

Council archive · source document

App C - Slope Stability - 14-16 Duke St · 132008.299.02

of 18

Text shows just the words. Original shows the document exactly as it was published.

          Text Figure 9: Zone of influence diagrams – footings to be founded below these lines

Site drainage should be designed to readily remove surface water and to prevent ponding of water on
subgrade areas during construction and also adjacent to foundations and perimeter slabs once
construction is completed.
If bored piles are adopted, it is recommended that footings be inspected by an RPEQ prior to placement
of steel reinforcement and pouring of concrete to confirm allowable bearing pressures and cleanliness of
excavations.
If any soil conditions encountered during construction are found to differ from those discussed in this
report, Tectonic should be notified immediately, and an inspection carried out to determine if changes to
footing design are required.

4.4       Retaining Structures
Retaining structures must be founded as per the recommendations in Section 4.3 above. Retaining
structures greater than 1 m high, or those required to support surcharge loads or sloping backfill, will
require engineer design and certification of construction. Retaining wall design should be carried out in
accordance with AS4678-2002 Earth retaining structures.
The parameters outlined in Table 3 may be adopted for retaining wall design. The values in Table 3
assume that the walls are fully drained, and no allowance is included for hydrostatic pressures,
construction loading, up-slope footing loadings, the effects of sloping ground and backfill compaction
stresses. Any temporary shoring required to support excavations during construction may also be
designed using the parameters in Table 3.
Table 3: Retaining Structure Design Parameters
                                                                  Lateral earth pressure coefficients
                      Unit weight           Friction angle Ø      Ka                     Ko              Kp
 Retained material
                      (kN/m3)               (°)                   (Cantilever wall)      (Non-yielding
                                                                                         wall)
 Loose Sands          17                    28                    0.36                   0.53            2.77

 Medium Dense         18                    33                    0.29                   0.46            3.39
 (or Denser) Sands
 Future Fill          *                     *                     *                      *               *


Note:   * depends on fill material type and level of compaction




21 October 2025
25317-001-Rev0                                                                                                  12 of 13

Used in these records

About this file

File size
4.2 MB (large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

App C - Slope Stability - 14-16 Duke St.pdf · 4.2 MB (large file)

The download may take up to a minute.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.