Skip to the record
Accept no substitutions.

Council archive · source document

planning report 20 William st · MCU25/0054

of 16

Text shows just the words. Original shows the document exactly as it was published.

Check the original when the exact wording matters.

                                        6.0 Conclusion
This application seeks a Development Permit for Material Change of Use for Multiple dwellings (3
units), associated Operational Works (Landscaping, Access, Car parking, Earthworks, Stormwater)
and Reconfiguring a lot (1 lot into 4 lots) for community title, situated at 20 William Street, Noosaville.
The use is a consistent code assessable development within the High Density Residential Housing
Zone. The assessment finds the design meets the relevant Acceptable and Performance Outcomes.
The Planning Act 2016 prescribes that a code assessment must be carried out only—
          (a) against the assessment benchmarks in a categorising instrument for the development (The Noosa Plan
              2020); and
          (b) having regard to any matters prescribed by regulation.
Council, after carrying out the assessment—

      (a) must decide to approve the application to the extent the development complies with all of the assessment
          benchmarks for the development; and
      (b) may decide to approve the application even if the development does not comply with some of the assessment
        benchmarks; and
Examples—
                   1        An assessment manager may approve an application for development that does not comply
                            with some of the benchmarks if the decision resolves a conflict between the benchmarks.
                   2        An assessment manager may approve an application for development that does not comply
                            with some of the benchmarks if the decision resolves a conflict between the benchmarks and
                            a referral agency’s response.
      (c) may impose development conditions on an approval; and
      (d) may, to the extent the development does not comply with some or all the assessment benchmarks, decide to
          refuse the application only if compliance cannot be achieved by imposing development conditions.
Example of a development condition—
a development condition that affects the way the development is carried out, or the management of uses or works that
are the natural and ordinary consequence of the development, but does not have the effect of changing the type of
development applied for



The assessment finds the development generally complies with all Acceptable Outcomes of the
applicable codes. The Assessment Manager’s favourable consideration of the above development
application is therefore recommended.




                                                                                                         Page 16 of 16

Used in these records

About this file

File size
2.2 MB (large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

planning report 20 William st.pdf · 2.2 MB (large file)

The download may take up to a minute.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.