Approved SPA Decision Notice [As Published] · 142010.662

                                                                                          2010/662



3.    Roof and surface runoff connection to Council’s drainage system shall be as shown on
      drawing No. 10-1708 SW1A prepared by Mike O’Regan and Associates dated 20 June
      2010.
4.    A footpath 1.5 metres wide shall be constructed across the full frontage of the development.
      The footpath shall have a slip resistant surface. The alignment shall be determined on site
      with Council’s Construction Technical Officer. The expansion joints in any bikeway/footpath
      shall be “sawcut”, not trowel jointed.
5.    Suitable root barriers shall be installed where proposed trees are adjacent to paths,
      pavement etc in accordance with Council’s Planning Scheme Policy PSP03 Landscaping
      Plants and Guidelines.
6.    Suitable sediment control devices ("in pit” pollution control devices) shall be temporarily
      installed into the first existing external downstream stormwater structure.
      These devices are to be checked and cleaned on a regular basis and specifically after each
      rain event.
      These devices are to remain in place during the civil works and construction phases of the
      development.
      The location and type of device to be installed shall be established at the “pre start” meeting
      with Council’s Engineering Officer Construction and shall be installed prior to the
      commencement of any works.
7.    Council’s Engineering Officer Construction (ph 07 5475 9866), shall be given seven (7) days’
      notice of intention to commence works to arrange a “pre start” meeting prior to the
      commencement of works.
8.    The principal contractor must have all the appropriate insurance and public liability
      documentation to carry out the works. The principal contractor is also responsible to ensure
      that any sub contractors also have the appropriate insurance and public liability
      documentation.
9.    Prior to the “pre start” meeting, the principal contractor must be provided with a copy of
      Council’s signed approved drawings and conditions by the applicant.
10.   Please provide one copy (A3 size) of the approved plans and a copy of the job specifications
      for Council’s Construction Technical Officer.
11.   The Consulting Engineers for the project shall be currently Registered Professional
      Engineers of Queensland (RPEQ). The Consulting Engineers are responsible for arranging
      all inspections with Council’s Engineering Officer Construction or nominated staff.
12.   Prior to works commencing, Council is to be advised of the Engineer (RPEQ) supervising the
      project. (This person will be the contact for the project).
13.   Council standards shall apply to these works unless otherwise modified herein.
14.   The person acting on this permit shall ensure that its consultants and contractors take all
      reasonable care during the construction of the engineering works to ensure that Council
      property, road pavements or facilities (such as underground drainage, water supply,
      sewerage, footpaths, kerbing, landscaping, street furniture etc.) are protected against any
      damage or interference whatsoever.
      If any Council property or facilities should be damaged by the Applicant or any of its
      Consultants or Contractors through any cause whatsoever in the course of, directly or
      indirectly, carrying out the engineering works, the Applicant and/or its Contractors shall
      forthwith notify the Chief Executive Officer, Sunshine Coast Regional Council, and shall
      forthwith rectify the damage to that property or facility at its cost and to the satisfaction of the
      Chief Executive Officer, Sunshine Coast Regional Council.

                                                                                        Page 2 of 8