Existing Council MCU RAL and OPW Approval

Noosa Council documents




               26.    Easements must be created over all existing and proposed public infrastructures within the
                      site if not already created unless approved otherwise in writing by the respective service
                      authority.
               27.    Any easements for services must be designed in accordance with the planning scheme or
                      the requirement of relevant service authority and granted at no cost to the Grantee. Where
                      the Grantee is Council or a service authority, the easement documentation must be in
                      accordance with the Grantee’s standard easement terms.
               28.    All building works and structures must be kept clear of any existing or proposed easements
                      on the subject land, unless agreed otherwise in writing by the Grantee.
               RECONFIGURATION OF A LOT – RAL18/0013
                      When Conditions Must Be Complied With
               29.    Unless otherwise stated, all works required by the conditions of this Decision Notice must be
                      completed prior to submission of the subdivision plan to Council for compliance assessment.
                      Approved Plans
               30.    Development undertaken in accordance with this approval must generally comply with the
                      approved plans of development. The approved plans are listed in the following table unless
                      otherwise amended by these conditions.

                        Plan No.          Rev.         Plan/Document Name                               Date

                        Drawing 1         -            Access easement plan, Project Urban              25/07/2018

               31.    All lot numbering on the subdivision plan to be submitted to Council for compliance
                      assessment must remain as shown on the Approved Plans.
               32.    The development must be undertaken and operated in a manner that causes no detrimental
                      effect upon the amenity of the neighbourhood by reason of the creation of excessive noise,
                      lighting nuisance or other emissions.
                      Boundary Encroachments
               33.    Certification must be submitted to Council from a Licensed Surveyor which certifies that:
                      a.      all constructed access and roadworks (including associated fill batters and retaining
                              walls) are fully contained within a dedicated reserve or registered easement
                      b.      all utility services and connections (eg. electricity, telecommunications, water,
                              sewerage) are wholly located within the lot they serve or alternatively included within
                              an easement
                      c.      all existing effluent disposal areas are wholly located within the lot they serve and
                              comply with the boundary setback requirements of the Plumbing and Drainage Act
                              2002 and associated codes and requirements
                      d.      all retaining walls and structures are fully contained within the lot they retain
                      e.      any fill, including fill batters, are wholly contained within the subject site and not on
                              adjacent properties
                      f.      for the community title scheme, the road pavement changes required by this Decision
                              Notice accurately demarcate the boundaries of the public and private land.
                      Community Management Statement
               34.    Any proposed Community Management Statement required for the development pursuant to
                      the Body Corporate and Community Management Act 1997 must be submitted to Council for
                      endorsement at the same time as submission of the subdivision plan to Council for
                      compliance assessment.




                                                                                                           Page 5 of 19
Document Set ID: 20742186
Version: 6, Version Date: 28/11/2018                                                                Print Date: 28 November 2018, 4:15 PM