Skip to the record
The definitive source for everything Noosa Council.

Council archive · source document

Noosa Springs SMP_Rev 4 · OPW17/0612

Attached to the e-mail Operational Works Application OPW17/0612 2 of 2– Precinct E2 Noosa Springs, Noosa Heads (MCU15/0109).

of 48

Text shows just the words. Original shows the document exactly as it was published.

Check the original when the exact wording matters.

Very large file (13.8 MB): the original may take a few minutes to open or download. The page text below is quick to read.

ALTUM CONSTRUCTIONS
PRECINCT F & E2 NOOSA SPRINGS DEVELOPMENT



7.         QUALIFICATIONS
           a.   In preparing this document, including all relevant calculation and modelling, Engeny
                Management Pty Ltd (Engeny) has exercised the degree of skill, care and diligence
                normally exercised by members of the engineering profession and has acted in
                accordance with accepted practices of engineering principles.

           b.   Engeny has used reasonable endeavours to inform itself of the parameters and
                requirements of the project and has taken reasonable steps to ensure that the works
                and document is as accurate and comprehensive as possible given the information
                upon which it has been based including information that may have been provided or
                obtained by any third party or external sources which has not been independently
                verified.

           c.   Engeny reserves the right to review and amend any aspect of the works performed
                including any opinions and recommendations from the works included or referred to in
                the works if:

                (i)   Additional sources of information not presently available (for whatever reason)
                      are provided or become known to Engeny; or

                (ii) Engeny considers it prudent to revise any aspect of the works in light of any
                     information which becomes known to it after the date of submission.

           d.   Engeny does not give any warranty nor accept any liability in relation to the
                completeness or accuracy of the works, which may be inherently reliant upon the
                completeness and accuracy of the input data and the agreed scope of works. All
                limitations of liability shall apply for the benefit of the employees, agents and
                representatives of Engeny to the same extent that they apply for the benefit of
                Engeny.

           e.   This document is for the use of the party to whom it is addressed and for no other
                persons. No responsibility is accepted to any third party for the whole or part of the
                contents of this report.

           f.   If any claim or demand is made by any person against Engeny on the basis of
                detriment sustained or alleged to have been sustained as a result of reliance upon the
                report or information therein, Engeny will rely upon this provision as a defence to any
                such claim or demand.

           g.   This report does not provide legal advice.




     Job No. M7130_001                                                                             Page 18
                                                                                    Rev 4 : 7 December 2017

Used in these records

About this file

File size
13.8 MB (very large file)
File type
PDF

No other editions are linked here.

Original file

Log in to download the original file

Noosa Springs SMP_Rev 4.pdf · 13.8 MB (very large file)

The download may take a few minutes. On mobile data, it is best to wait for Wi-Fi.

The supporting record

Open full page ↗

Source document

Analyse documents ↗Open full page ↗

My Comparisons

Choose two to four records of the same kind. Drag using a handle or use the “Compare” buttons.

Your selected records are saved in this browser for your account. Results use the filters on the page where you choose “Compare selected”.